User manual TEAC LP-R400

[. . . ] The lightning flash with arrowhead symbol, within an equilateral triangle, is intended to alert the user to the presence of uninsulated "dangerous voltage" within the product's enclosure that may be of sufficient magnitude to constitute a risk of electric shock to persons. 8) Do not install near any heat sources such as radiators, heat registers, stoves, or other apparatus (including amplifiers) that produce heat. 9) Do not defeat the safety purpose of the polarized or grounding-type plug. If the provided plug does not fit into your outlet, consult an electrician for replacement of the obsolete outlet. [. . . ] < When the remote control unit is not to be used for a long time (more than a month), remove the batteries from the remote control unit to prevent them from leaking. If they leak, wipe away the liquid inside the battery compartment and replace the batteries with new ones. < Do not heat or disassemble batteries and never dispose of old batteries by throwing them in a fire. STEREO FM stereo broadcasts are received in stereo and the "STEREO" indicator lights in the display. < If the sound is distorted and the "STEREO" indicator flashes, the signal is not strong enough for good stereo reception. Hold down the TUNING button ( or ) until the frequency display begins to change. AM broadcast Turn around the AM antenna and/or the unit to find the best position for AM stations. FM broadcast Extend and turn around the FM antenna so that you can receive the stations clearly. When the or button is pressed momentarily, the frequency changes by a fixed step. Press the or button repeatedly until the station you want to listen to is found. You can store FM and AM stations into preset channels 1 to 9 respectively. < You can tune in another station even after the ENTER/MEMORY button has been pressed. < Before use, completely loosen the transportation screw by turning them clockwise with a coin and remove the stylus guard. 1 Press the PHONO/AUX button once or twice to select 5 Gently push the clamper to the right to release the tone Be careful not to pinch your finger. When the playback has been finished, the tone arm automatically returns to the tone arm holder and the rotation stops. To stop playback manually, slightly lift the tone arm using the cue lever and return it to the tone arm holder. 8 Gently lower the tone arm by slowly releasing the cue You can lower the tone arm manually if the cue lever has not been raised. < Playing records with the dust cover down will prevent dust from settling on the turntable. Please do not place anything on top of the turntable cover, especially while playing a record. Wait until the total number of the tracks and the total play time of the disc are displayed. CD: A commercial pre-recorded CD CD-R: A finalized CD-R CD-RW: A finalized CD-RW NO TOC CD-R: A CD-R which has yet to be finalized NO TOC CD-RW: A CD-RW which has yet to be finalized blank: No disc or unreadable disc < The disc must be placed in the center of the disc tray. If the disc is not correctly loaded, it may not be possible to open the tray again once it has closed, so you should ensure the disc is always centered on the tray. [. . . ] When the operation has been finished, the display returns to the track/time display. If you are going to erase a track or tracks, make sure that they are recordings that you really want to erase. If you experience any problems with the unit, please take a moment to look through this chart and see if you can solve the problem yourself before you call your dealer or a TEAC service center. Check and make sure the AC source is not a switched outlet and if it is, the switch is turned on. [. . . ]