User manual TEAC HDD0050A

[. . . ] 3) Heed Warnings -- All warnings on the product and in the operating instructions should be adhered to. 4) Follow Instructions -- All operating and use instructions should be followed. 5) Cleaning -- Unplug this product from the wall outlet before cleaning. 6) Attachments -- Do not use attachments not recommended by the product manufacturer as they may cause hazards. [. . . ] < Copy-protected discs and other discs that do not conform to the CD standard may not play back correctly in this player. If you use such discs in this unit, TEAC Corporation and its subsidiaries cannot be responsible for any consequences or guarantee the quality of reproduction. If you experience problems with such non-standard discs, you should contact the producers of the disc. < If you are in any doubt as to the care and handling of any disc, read the precautions supplied with the disc, or contact the disc manufacturer directly. < Should the disc become dirty, wipe the surface from the center hole outward towards the outer edge with a soft, dry, lint-free cloth: < Never use chemicals such as record (LP) sprays, antistatic sprays or fluids, benzine or thinner to clean the discs. such chemicals will do irreparable damage to the disc's plastic surface. < Discs should be returned to their cases after each use to avoid dust and scratches that may eventually cause your disc to skip. < Do not play any disc that is warped, scratched, deformed or damaged. Playing such discs may cause irreparable harm to the playback mechanism. CAUTION < Turn off the power of all the equipment before making connections. < Read instructions of each component you intend to use with this unit. < As a convenience , a set of tapered plastic anchors is supplied. If you chose to use these anchors, drill a pilot hole using a 6 mm drill bit then tap the anchor into the pilot hole. Only use these anchors if they are appropriate for the materials onto which the unit is to be mounted. Before going on, connect the speakers and the subwoofer using the supplied speaker cables (see page 6-7). Battery Replacement If the distance required between the remote control unit and main unit decreases, the battery is exhausted. Precautions concerning batteries Do not heat or disassemble batteries and never dispose of old batteries by throwing them in a fire. Note: Ensure that the speaker locks onto the hooks and that the hooks are strong enough to support the weight before removing your hands. The MC-DX32i comes mounted with an adapter for iPod with color display (40GB, 60GB), "60GB (color) + Photo 40GB/60GB". To play your iPod through the MC-DX32i, you have first to check if the factory mounted adapter fits your model of iPod. If it does not, you have to replace it with a correct one, as explained below. < Use a commercially available adapter to play iPod with dock connector (with four buttons under the display). [. . . ] If the power switch of the subwoofer turned off, the settings kept in memory (clock, preset stations, timer setting) will be erased. If the power switch of the subwoofer turned off, the settings kept in memory (clock, preset stations, timer setting) will be erased. 1 If the unit is on, press the STANDBY/ON switch to turn Seconds and release it when "12H" or "24H" appears on the display. < If you leave the unit idle for 7 seconds, the time setting mode will be cancelled. [. . . ]