User manual TEAC GR-7I

[. . . ] Includes adapters for: iPod nano iPod with video iPod mini iPod with Click Wheel iPod with color display Adapters sold separately: iPod with dock connector The lightning flash with arrowhead symbol, within an equilateral triangle, is intended to alert the user to the presence of uninsulated "dangerous voltage" within the product`s enclosure that may be of sufficient magnitude to constitute a risk of electric shock to persons. 1) Read Instructions -- All the safety and operating instructions should be read before the product is operated. 2) Retain Instructions -- The safety and operating instructions should be retained for future reference. 3) Heed Warnings -- All warnings on the product and in the operating instructions should be adhered to. [. . . ] < As the unit may become warm during operation, always leave sufficient space around the unit for ventilation. < The voltage supplied to the unit should match the voltage as printed on the rear panel. If you are in any doubt regarding this matter, consult an electrician. Also avoid locations subject to vibrations and excessive dust, heat, cold or moisture. < Do not open the cabinet as this might result in damage to the circuitry or electrical shock. If a foreign object should get into the unit, contact your dealer or service company. < When removing the power plug from the wall outlet, always pull directly on the plug, never yank the cord. < Do not attempt to clean the unit with chemical solvents as this might damage the finish. The provided Remote Control Unit allows the unit to be operated from a distance. When operating the remote control unit, point it towards the remote sensor on the front panel of the unit. < Even if the remote control unit is operated within the effective range, remote control operation may be impossible if there are any obstacles between the unit and the remote control. < If the remote control unit is operated near other products which generate infrared rays, or if other remote control devices using infrared rays are used near the unit, it may operate incorrectly. (Underside of the unit) These batteries supply backup power to the built-in clock when the unit is momentarily disconnected from the AC power line. < If the unit is disconnected from the power supply and the batteries have been completely exhausted for about an hour, clock and timer settings will be lost. < Be sure to insert the batteries with correct positive "+" and negative "_" polarities. < When the remote control unit is not to be used for a long time (more than a month), remove the batteries from the remote control unit to prevent them from leaking. If they leak, wipe away the liquid inside the battery compartment and replace the batteries with new ones. < Do not heat or disassemble batteries and never dispose of old batteries by throwing them in a fire. Battery Replacement If the distance required between the remote control unit and main unit decreases, the battery is exhausted. < Read the instructions of each component you intend to use with this unit. While in FM mode, tune in an FM station and extend the lead to find the best position for the reception. This antenna may need to be repositioned if you move your unit to a new location. [. . . ] Press the TUNING/SKIP button repeatedly until the station you want to listen to is found. Or/) for more than 2 seconds and release it when the frequency display begins to change. < If the source is set to "iPod" but no iPod is set, the unit will turn on into TUNER mode. < When the source is set to "RADIO" and the unit turns on, it will tune in to the station you selected last time. [. . . ]