User manual TEAC GF-650

[. . . ] The lightning flash with arrowhead symbol, within an equilateral triangle, is intended to alert the user to the presence of uninsulated "dangerous voltage" within the product's enclosure that may be of sufficient magnitude to constitute a risk of electric shock to persons. 8) Do not install near any heat sources such as radiators, heat registers, stoves, or other apparatus (including amplifiers) that produce heat. 9) Do not defeat the safety purpose of the polarized or grounding-type plug. If the provided plug does not fit into your outlet, consult an electrician for replacement of the obsolete outlet. [. . . ] < Read the instructions of each component you intend to use with this unit. To prevent hum and noise, avoid bundling the signal interconnection cables together with the AC power cord. While in FM mode, tune in an FM station and extend the lead to find the best position for the reception. This antenna may need to be repositioned if you move your unit to a new location. Make sure to connect: white plug q white jack (L: left channel) red plug q red jack (R: right channel) After all other connections have been completed, connect the plug to the AC wall socket. Be sure to connect the power cord to an AC outlet which supplies the correct voltage. Before use, completely loosen the screws by turning them clockwise with a coin or screwdriver. When operating the remote control unit, point it towards the REMOTE SENSOR. Then insert the plug from your headphones into the PHONES jack, and adjust the volume by turning the VOLUME knob. The sound from speakers will be cut off while the headphones are plugged in. In CD or PHONO/AUX mode, use this button to open and close the disc tray. Note: To simplify explanations, instructions refer to names of buttons and controls on the front panel, making no mention of the use of remote control unit. Caution: < Before use, completely loosen the shipping screws by turning them clockwise with a coin and remove the stylus guard. < When turning on the power to the unit, the tone arm may move if the cum was subjected to shock during transportation and has been displaced. When you use the GF-650 for the first time, turn on the power to the unit leaving the vinyl tie intact to prevent the tone arm from moving and leave the unit alone for more than 30 seconds. 1 Press the PHONO/AUX button once or twice to select 1 Press the POWER switch to turn the unit on. Move the tone arm gently to the edge of the record (or the starting point of a track), and gently lower the tone arm. When the record finishes playing, the tone arm will automatically return to the tone arm holder and the turntable will stop. < Playing records with the dust cover down will prevent dust from settling on the turntable. Please do not place anything on top of the turntable cover, especially while playing a record. < Don't rock the unit nor switch off the power during playback. < The tone arm automatically returns to the tone arm holder when it reaches the end of recording. [. . . ] When the operation has been finished, the display returns to the track/time display. If you are going to erase a track or tracks, make sure that they are recordings that you really want to erase. If you experience any problems with the unit, please take a moment to look through this chart and see if you can solve the problem yourself before you call your dealer or a TEAC service center. Check and make sure the AC source is not a switched outlet and if it is, the switch is turned on. [. . . ]