User manual TEAC FD235HF

[. . . ] TEAC FD-235 Series 3 1/2" 1. 44 MB Floppy Disk Drive Installation Guide 3 1/2'' diskette insertion window Activity indicator Eject Button Your FD-235 package includes: * FD-235 3 1/2" floppy disk drive * Installation Guide Introduction Thank you for purchasing the TEAC FD-235 Series 1. 44 MB floppy disk drive. [. . . ] Your system may also have a single ground wire attached to the floppy disk drive. Install the FD-235 Series 1. 44 MB into an available drive bay. Rear View of FD-235 Pin #1 indicator stripe (red or blue) Flat "ribbon" cable Pin #1 Power connector Traditional power connector from PC power supply FIGURE A 2 Configuring for A: or B: drive Use a standard IBM PC compatible cable with a twist at the end connector (Figure B) to complete installation. Cable's colored-line denotes Line 1 to match to Pin 1 on drive and motherboard's connectors. To configure as your A: drive, connect the FD-235 Series floppy drive to Connector A: on the flat "ribbon" cable. To configure as your B: drive, connect the FD-235 Series floppy drive to Connector B: on the flat "ribbon" cable. Connector B: is the middle connector of the cable as shown in Figure B. Make the correct changes to the CMOS BIOS setup after you install your FD-235. Upon rebooting, the Operating System (DOS, Windows) will recognize the floppy disk drive. [. . . ] Bad media or drive. Sector not found error. TEAC Tech Support: If you have questions on the floppy installation, please contact us: Phone: 323-727-4860 Fax: 323-869-8751 Email: dspdtsg@teac. com Hours: M-F 8am-5pm PST Website: www. teac. com/DSPD/techsupport. htm *IBM PC/AT are registered trademarks of International Business Machines Corp. Rev. [. . . ]