User manual TEAC DV-W58G

[. . . ] TEAC DV-W58G Dual DVD ± R/RW Drive Quick Installation Guide The TEAC DV-W58G is a modern high performance Dual DVD+/-R/RW drive. It offers reading speeds of 12x for DVD-ROM media and 40x for CD-ROM media. [. . . ] If there is only one hard disk in the PC the optical drive can be operated at the same IDE connection parallel to this hard disk. Important: The data rates of both devices may be decreased. X - - Cable Select: Master/slave detection is achieved by the controller. Audio-Cable 40-pin Datakabel Power Cable Installation and Connection Very important: Switch off your PC and any attached devices and disconnect the power cord(s). Do the same if the optical drive is reconfigured. (6) Close the case of the PC. Do not forget to connect other devices and accessories if there are any. (7) Connect the PC to the wall outlet and switch it on Important: If your PC will not start up correctly switch it off immediately and check all of the connections and jumper settings. Controls and Functions at the Front Panel (1) Open the case of your PC and lift it off carefully. (3) Locate a free slot for 13. 3cm/5. 25" drives and install the Drive using the provided four screws. Emergency Eject Busy-LED Eject Key Important: Do not use screws which are longer than 5 mm! (4) Connect the power cable and the 40-pin data cable (assure the correct orientation, pin 1 is often marked with a color stripe) to the drive. Usually sound cards offer more than one connector to connect an audio cable to. Please refer to the manual of the sound card to find the connector in question. Headphone Jack Volume-Control ON/BUSY indicator The indicator LED light in Seek, Play, Read, and Write operation. In the following table you will find a list including a description of the different drive states and their associated indicator states. Operation Write Audio Play Seek/Data Transfer At start LED Red LED lights Green LED flashes Green LED lights Green LED flashes Cleaning and maintenance of your DV-W58G DV-W58G will not need maintenance if used as specified in this manual. Usually there are only problems with dirty or defective CD/DVDs. Installing Drivers with Windows NT 4. 0 and OS/2 After installing the hardware, the reading functionality of the optical drive is activated with installing the drivers shipped with the corresponding operating system. The drivers may be configured and activated aided by the system control. Compatibility Devices or Interoperability to other IDE Important: Do not use cleaning CDs which will remove dirt of the lense of the laser aided by a little brush. [. . . ] (Default: ULTRA DMA Mode-2) DVD-ROM: 160ms typical (random stroke) CD-ROM : 160ms typical (random stroke), by TEAC standard 18sec of less (average) (excluding the multisession photo CD), by TEAC standard 2MB Block/10-15bits (DVD-ROM) Block/10-12bits (CD-ROM Mode-1) Block/10-9bits (CD-ROM Mode-2, ECC off) Auto eject or Auto inject 1x dual Color LED Stereo mini-jack 0. 7+/-0. 2Vrms 33Ohm Thumb wheel knob +5V, +12 IDE (ATAPI): ATA/ATAPI-5 Line out 0. 85+/-0. 15Vrms 47kOhm Mode setting straps (Master) Temperature 5 to 45degC, Hummidity 15 to 80% (non-condencation) Temperature -40 to 60degC, Hummidity 15 to 95% (non-condencation) 6 7 Front Panel Button Indicator (LED) Headphone Output Volume control Rear panel Power supply Interface connector Audio Output Strap switch Operating environment Place of Operation Place of storage 8 9 Dimensions/weight Dimensions (WxHxD) Weight 148. 4mm x 42. 8mm x 170. 0mm 900g UL, TÜV, FCC, CE 70, 000 POH (duty 25%) Warranty is provided under the terms of the TEAC warranty conditions. In case of warranty: www. teac. de/support 10 11 Safety standards Reliability: MTBF [. . . ]