User manual TEAC CD-W552G

DON'T FORGET : ALWAYS READ THE USER GUIDE BEFORE BUYING !!!

If this document matches the user guide, instructions manual or user manual, feature sets, schematics you are looking for, download it now. Diplodocs provides you a fast and easy access to the user manual TEAC CD-W552G. We hope that this TEAC CD-W552G user guide will be useful to you.


TEAC CD-W552G : Download the complete user guide (120 Ko)

You may also download the following manuals related to this product:

   TEAC CD-W552G (122 ko)
   TEAC CD-W552G (121 ko)
   TEAC CD-W552G BROCHURE (2150 ko)

Manual abstract: user guide TEAC CD-W552G

Detailed instructions for use are in the User's Guide.

[. . . ] TEAC CD-W552G Drive Quick Installation Guide The TEAC CD-W552G is a modern high performance CD-R / CD-RW drive. Read - Speed 52 x CD-ROM Write - Speed 52 x CD-R 32 x CD-RW Drive Installation Directions There are three possible positions for installation: Horizontal installation with the eject button to the right, and vertical installation in both possible directions. The installation position is not allowed to be tilted more than 5 degrees out of the vertical or 10 degrees out of the horizontal position. [. . . ] Important: The data rates of both devices may be decreased. X - - Cable Select: Master/slave detection is achieved by the controller. Audio-Cable 40-pin Datakabel Power Cable Installation and Connection Very important: Switch off your PC and any attached devices and disconnect the power cord(s). Do the same if the optical drive is reconfigured. (6) Close the case of the PC. Do not forget to connect other devices and accessories if there are any. (7) Connect the PC to the wall outlet and switch it on Important: If your PC will not start up correctly switch it off immediately and check all of the connections and jumper settings. Controls and Functions at the Front Panel (1) Open the case of your PC and lift it off carefully. (3) Locate a free slot for 13. 3cm / 5. 25" drives and install the Drive using the provided four screws. Emergency Eject Busy-LED Eject Key Important: Do not use screws which are longer than 5 mm! (4) Connect the power cable and the 40-pin data cable (assure the correct orientation, pin 1 is often marked with a color stripe) to the drive. Usually sound cards offer more than one connector to connect an audio cable to. Please refer to the manual of the sound card to find the connector in question. Headphone Jack Volume-Control ON/BUSY indicator The indicator LED light in Seek, Play, Read, and Write operation. In the following table you will find a list including a description of the different drive states and their associated indicator states. Operation Write Audio Play Seek/Data Transfer At start LED Red LED lights Green LED flashes Green LED lights Green LED flashes Cleaning and maintenance of your CD-W552G Drive will not need maintenance if used as specified in this manual. Usually there are only problems with dirty or defective CD. Installing Drivers with Windows NT 4. 0 and OS/2 After installing the hardware, the reading functionality of the optical drive is activated with installing the drivers shipped with the corresponding operating system. The drivers may be configured and activated aided by the system control. Compatibility Devices or Interoperability to other IDE Important: Do not use cleaning CDs which will remove dirt of the lense of the laser aided by a little brush. Any of these methods may cause damage to your Drive. Handling: Check the CD before inserting it into the drive. Especially at high reading velocities dirt may increase the number of reading errors. Very important: Shape CD, a kind of CD which is not shaped like the normal round CD, are not allowed to be used in this drive. [. . . ] supported DVD-R/CD-R media speed or data transfer rate of the PC) 4 Drive Performance Data transfer rate (Asynchronous transfer) Access time Starting time from power on Programmed I/O: 16. 6MB/s max. (Default: ULTRA DMA Mode-2) 100 ms typisch (pseudo-zufälliger Zugriff) entsprechend TEAC Standard 15 sec max. (excluding the multisession photo CD), by TEAC standard 2MB Block/10-12bits (Mode-1 and Mode-2, Form 1) Block/10-9bits (Mode-2 Form 2 and CD-DA) Auto eject or Auto inject 1x dual Color LED Stereo mini-jack 0. 7+/-0. 2Vrms 33Ohm Thumb wheel knob +5V, +12 IDE (ATAPI): ATA/ATAPI-5 Line out 0. 85+/-0. 15Vrms 47kOhm Mode setting straps (Master) Temperature 5 to 45degC, Hummidity 15 to 80% (non-condencation) Temperature -40 to 60degC, Hummidity 15 to 95% (non-condencation) 148. 4 x 42. 8 x 170. 0 mm 860 g UL, TÜV, FCC, CE 70, 000 POH (duty 25%) 5 Data buffer capacity Data read error rate Front Panel Button Indicator (LED) Headphone Output Volume control Rear panel Power supply Interface connector Audio Output Strap switch Operating environment Place of Operation Place of storage Dimensions/weight Dimensions (WxHxD) Weight 6 7 8 9 10 11 Safety standards Reliability: MTBF Warranty is provided under the terms of the TEAC warranty conditions. [. . . ]

DISCLAIMER TO DOWNLOAD THE USER GUIDE TEAC CD-W552G




Click on "Download the user Manual" at the end of this Contract if you accept its terms, the downloading of the manual TEAC CD-W552G will begin.

 

Copyright © 2015 - manualRetreiver - All Rights Reserved.
Designated trademarks and brands are the property of their respective owners.