User manual TEAC CD-RW880

[. . . ] The lightning flash with arrowhead symbol, within an equilateral triangle, is intended to alert the user to the presence of uninsulated "dangerous voltage" within the product's enclosure that may be of sufficient magnitude to constitute a risk of electric shock to persons. 8) Do not install near any heat sources such as radiators, heat registers, stoves, or other apparatus (including amplifiers) that produce heat. 9) Do not defeat the safety purpose of the polarized or grounding-type plug. If the provided plug does not fit into your outlet, consult an electrician for replacement of the obsolete outlet. [. . . ] Search for a part of a track During playback, hold down the MUSIC SKIP button (. Or /) of the main unit (or the SEARCH button (m or , ) of the remote control unit) and release it when the part you want to listen to is found. While in stop or playback mode, you can use the numeric buttons of the remote control unit to select a track. To play tracks 1 through 9, simply press the appropriate button (1 through 9). To play a track whose number is higher than 9, press the +10 button appropriate number of times to set the "tens" digit of the track number, followed by a single button to set the "units" digit. < Direct playback isn't possible during shuffle playback and programmed playback. Each time the TIME button is pressed, the display changes as follows: The tracks can be played randomly. When the shuffle playback of all the tracks has been finished, the unit stops and the shuffle playback mode is cancelled. < If you press the / button during shuffle playback, next track will be randomly selected and played. < If one of the following buttons is pressed, shuffle mode will be cancelled: SHUFFLE in the stop mode, OPEN/CLOSE, STANDBY/ON, POWER < Shuffle playback works with finalized discs only. Each time the REPEAT button is pressed, the repeat mode is changed as follows: Please note that CD-R/CD-RW discs that haven't been finalized cannot be used for A-B repeat. If you press the MUSIC SKIP button and select another track, the track you selected will be played repeatedly. it is also possible to select a track to be repeated in the stop mode. Press the REPEAT button twice and then select the track number by pressing the MUSIC SKIP button. Start playback and designate the point at which the A-B repeat should start (point A) by pressing the A-B button. When the point at which repeat playback should end (point B) is reached, press the A-B button again. < After designating point A, the SEARCH button can be used to fast-forward or fast-backward to point B. < If one of the following buttons is pressed, repeat mode will be cancelled: OPEN/CLOSE, STANDBY/ON, POWER < Repeat playback works with finalized discs only. < If one of the following buttons is pressed, A-B repeat mode will be canceled: A-B, STOP, OPEN/CLOSE, STANDBY/ON, POWER < Shuffle playback does not work during programmed playback. 3 When the selection of track numbers has been finished, You can also use the MUSIC SKIP button and the PROGRAM button to program tracks. Before you start recording, make sure that you understand the following points: < The unit requires Digital Audio CD-R or CD-RW media for recording. < Once you have recorded on a CD-R disc, the data cannot be erased from it. [. . . ] ENGLISH If you want to erase two or more tracks at once, press the MUSIC SKIP button repeatedly to select the first track number to be erased. For example, if 12 tracks have been recorded on the disc, "ERASE 10-12" means the last 3 tracks (No. < This will not appear when only one track is recorded on the disc. ), "REFRESH" might be effective to make the disc usable again. [. . . ]