User manual TEAC AG-V8520

[. . . ] Also avoid locations subject to vibrations and excessive dust, heat, cold or moisture. < Do not open the cabinet as this might result in damage to the circuitry or electrical shock. If a foreign object should get into the unit, contact your dealer or service company. < When removing the power plug from the wall outlet, always pull directly on the plug, never yank the cord. [. . . ] < If the remote control unit is operated near other appliances which generate infrared rays, or if other remote control devices using infrared rays are used near the unit, it may operate incorrectly. CAUTION: < Switch off the power to all equipment before making connections. < Read the instructions of each component you intend to use with this unit. To prevent hum and noise, avoid bundling the signal interconnection cables together with the AC power cord or speaker cables. Caution: To avoid damaging the speakers with a sudden high-level signal, be sure to switch the power off before connecting the speakers. Generally, the + side of the speaker cable is marked to make it distinguishable from the - side of the cable. connect this marked side to the + terminal and the unmarked side to the black - terminal. < Prepare the speaker cables for connection by stripping off approximately 10 mm or less of the outer insulation. (Removing too much insulation may lead to a short circuit if the bared wires should come in contact with each other. Make sure to connect: white plug q white jack (L: left channel) red plug q red jack (R: right channel) Make sure to connect: white plug q white jack (L: left channel) red plug q red jack (R: right channel) Connect the turntable's ground cord to SIGNAL GND terminal. Caution: The metal portions of the two separate wires should not touch or an electrical short can occur. To listen to a source other than TAPE If the tape monitor function is ON ("TAPE MON " indicator is lit), press the TAPE MONITOR button to turn it off. This control is used for adjusting the level of the low frequency sound range. Caution: If the speakers are connected to the SPEAKERS A terminals, turn the SPEAKER A on using the SPEAKERS A button. If no speakers are connected to the SPEAKER B terminal, be sure to turn off the SPEAKER B button, or no sound will be output from SPEAKER A, and vice versa. This control is used for adjusting the level of the high frequency sound range. For private listening, first reduce the volume level on the receiver to minimum. Then insert the plug from your headphones into the PHONES jack, and adjust the volume by turning the VOLUME knob. If you want to cut off the sound from speakers, press the SPEAKERS button to turn it off. CAUTION Always lower the volume level prior to plugging in your headphones. TO AVOID DAMAGING YOUR HEARING - Do not place your headphones on your head until after you have plugged them in. F How to adjust the balance between the left and right speakers This button compensate for the loss of bass at low volumes. [. . . ] The preset channels stored in memory are scanned at 5 seconds intervals. When the station you want to listen to is found, press the MEMORY SCAN button again to stop scanning. The Radio Data System(RDS) is a broadcasting service which allows stations to send additional information along with the regular radio programme signal. AFFAIRS : a kind of suggestion including practical announcements other than news, documents, discussion, analysis and so on. [. . . ]