User manual TEAC AG-790

[. . . ] All electrical and electronic products should be disposed of separately from the municipal waste stream via designated collection facilities appointed by the government or the local authorities. The correct disposal of your old appliance will help prevent potential negative consequences for the environment and human health. For more detailed information about disposal of your old appliance, please contact your city office, waste disposal service or the shop where you purchased the product. CAUTION Ensure this product is not exposed to dripping or splashing and that no object filled with liquids, such as vases, is placed on the product. [. . . ] Insert the wire into the terminal fully and turn the terminal cap clockwise to securely connect it . Make sure none of the wire insulation is under the terminal, only the bare, stripped wire. In these cases, press the RESET switch once or twice with a pencil or a ball-point pen lightly. All the settings kept in memory (such as preset stations) will be erased. When the power switch of the main unit is off, the outlet is inactive. Caution: Make sure that the total power consumption of all equipment connected to the outlet does not exceed 100 watts or 1A. Be sure to connect the power cord to an AC outlet which supplies the correct voltage. The equipment draws nominal non-operating power from the AC outlet with its POWER switch in the OFF position. In the standby mode, press the POWER button of the remote control unit or the Input buttons of the main unit to turn the unit on. When operating the remote control unit, point it towards the REMOTE SENSOR. For private listening, insert the headphones plug into this jack, and adjust the volume by turning the VOLUME knob. When the power switch of the main unit is depressed, use this button to turn the unit on or standby. When the unit is in the standby mode, press any one of these buttons to turn the unit on. Note: To simplify explanations, instructions in this manual refer to the names of the buttons on the front panel only. < When the unit is turned on, the MUTING indicator lights momentarily. < When the unit is in the standby mode and the standby indicator is lit, press the POWER button of the remote control unit or any of the Input buttons of the main unit (TUNER, PHONO, CD, TAPE MONITOR or VIDEO/AUX) to turn the unit on. < If a 3-head cassette tape deck is connected to TAPE MONITOR (PLAY and REC) jacks, and if the tape monitor function is set to on during recording, you can listen to not the source sound but the sound being recorded. Press the TAPE MONITOR button to turn on or off the tape monitor function. Tape Monitor Press the TAPE MONITOR button to turn on or off the tape monitor function. When the tape monitor is on, the "TAPE MON " indicator lights on the display. To listen to the TAPE, turn the tape monitor function ON using the TAPE MONITOR button. To listen to a source other than TAPE If the tape monitor function is ON ("TAPE MON " indicator is lit), press the TAPE MONITOR button to turn it off. [. . . ] Sound cuts off during listening to the music or no sound even though power is ON. E Install the antenna again after relocating it to a better reception position. E Use remote control unit within the range (5m /15ft) and point at the front panel. If normal operation is not restored, unplug the power cord from the outlet and plug it again. [. . . ]