User manual TEAC AD-800-B

[. . . ] The lightning flash with arrowhead symbol, within an equilateral triangle, is intended to alert the user to the presence of uninsulated “dangerous voltage” within the product’s enclosure that may be of sufficient magnitude to constitute a risk of electric shock to persons. The exclamation point within an equilateral triangle is intended to alert the user to the presence of important operating and maintenance (servicing) instructions in the literature accompanying the appliance. Do not install near any heat sources such as radiators, heat registers, stoves, or other apparatus (including amplifiers) that produce heat. Do not defeat the safety purpose of the polarized or groundingtype plug. [. . . ] 20 Programmed Playback (1) This function can be used in CD and USB modes. 3 Press the CD/USB Skip ( or ) buttons to select a track/file, then press the PROGRAM button. 1 When playback is stopped, press the PROGRAM button to enter program mode. Example when in CD mode To stop programming, press the CD/USB Stop ( ) button. Programming is cancelled, but the program contents are retained in memory. If you want to restart program playback, press the PROGRAM button, and then press the CD/USB Play ( ) button. 4 2 (When programming MP3 files) Press the CD/USB Skip ( or ) buttons to select a folder, then press the PROGRAM button. When the selection of track/file numbers is completed, press the CD/USB Play ( ) button to start program playback. After program playback finishes, press the CD/USB Play ( button to play the program again. MP3 files not located in a specific folder are in the “001” (ROOT) folder. ) You can use the CD/USB Skip ( and ) buttons during program playback to select and play other tracks/files in the program. €REPEAT 1” and “REPEAT ALL” playback are possible during program playback. When set to “REPEAT ALL” mode, the programmed tracks/files will be played repeatedly. 21 Programmed Playback (2) Adding tracks/files to the end of the program When playback is stopped, press the PROGRAM button repeatedly until “TRACK 00” appears on the display. Overwriting part of the program When playback is stopped, press the PROGRAM button repeatedly until the program number of the track that you want to change appears on the display. Press repeatedly Press repeatedly Select a track/file number you want to add using the CD/USB Skip ( and ) buttons, and then press the PROGRAM button. Program number to be changed Select the track/file number that you want to add using the CD/ USB Skip ( and ) buttons, and then press the PROGRAM button. The selected track/file is added to the program, replacing the track that had been at that program number before. 22 Checking the program order Clearing the program Press repeatedly Hold down more than 1 sec. The numbers of the programmed tracks/files and their program numbers will be shown in order. When playback is stopped, press the PROGRAM button, followed by the CLEAR button or CD/USB Stop ( ) button more than 1 second. The PROGRAM indicator disappears and all the contents of the program are cleared. [. . . ] If this occurs, turn the power off and, after waiting for about one minute, restart operation. 50–12, 000 Hz ± 3 dB, metal 50–12, 000 Hz ± 3 dB, chrome 50–12, 000 Hz ± 3 dB, normal Signal-to-noise ratio (overall) 59 dB (Dolby NR off, 3% THD level, weighted), 69 dB (DOLBY NR on, over 5 kHz) Rewinding time . €20˚ C – +55˚ C Included Accessories Remote control unit (RC-1257) Batteries (AAA) for remote control unit (2) Stereo RCA pin cables (2) Distributor list Owner’s manual (this document) Quick start guide for recording Warranty card Design and specifications are subject to change without notice. ENGLISH For European customers Disposal of electrical and electronic equipment (a) All electrical and electronic equipment should be disposed of separately from the municipal waste stream via collection facilities designated by the government or local authorities. [. . . ]