User manual TEAC 5FD0050A

[. . . ] Protect the power cord from being walked on or pinched particularly at plugs, convenience receptacles, and the point where they exit from the apparatus. Use only with the cart, stand, tripod, bracket, or table specified by the manufacturer, or sold with the apparatus. When a cart is used, use caution when moving the cart/ apparatus combination to avoid injury from tip-over. Unplug this apparatus during lightning storms or when unused for long periods of time. [. . . ] If you use such discs in this unit, TEAC Corporation and its subsidiaries cannot be responsible for any consequences or guarantee the quality of reproduction. If you have problems with such nonstandard discs, you should contact the producers of the disc. < To remove a disc from its storage case, press down on the center of the case and lift the disc out, holding it carefully by the edges. < If you are in any doubt as to the care and handling of a CD-R/ CD-RW disc, read the precautions supplied with the disc, or contact the disc manufacturer directly. < Should the disc become dirty, wipe the surface radially (from the center hole outward towards the outer edge) with a soft and dry cloth. < Never use such chemicals as record sprays, antistatic sprays or fluid, benzine or thinner to clean the discs. such chemicals will do irreparable damage to the disc's plastic surface. < Discs should be returned to their cases after use to avoid dust and scratches that could cause the laser pickup to "skip". Playing such discs may cause irreparable harm to the playing mechanisms. < CD-R and CD-RW discs are more sensitive to the effects of heat and ultraviolet rays than ordinary CDs. It is important that they are not stored in a location where direct sunlight will fall on them, and which is away from sources of heat such as radiators or heat-generating electrical devices. Then set the SYSTEM CONTROL SELECTOR switch on this unit to "SYSTEM". ) Available system control functions are as follows: N When you turn on or standby the AG-H600 series receiver using the remote control unit (RC-1181) of the receiver, this unit is also turned on or standby synchronously. N When you change the source from CD to another on AG-H600 series receiver, playback stops and display turns off on this unit. When you want to use the system control functions, connect the SYSTEM CONTROL jacks (see C ), and set the switch to "SYSTEM". < The STANDBY/ON button on the remote control unit of this unit does not work while the switch is set to "SYSTEM". < When you do not use the system control functions or do not have a AG-H600 series receiver, set the switch to "SINGLE". The standby indicator lights orange when the unit is in the standby mode. < Playback stops automatically after all the tracks/files are played. < "No Disc" appears on the display when no disc is loaded in the unit. < MP3/WMA files recorded out of folders are recognized as the contents of "ROOT" folder. < If there are folders that has no MP3/WMA file, this unit skips them. [. . . ] To delete a track from the program While playback is stopped, press the PROGRAM button repeatedly until the track number to be deleted appears on the display, then press the CLEAR button. Each time you press the DIMMER button, the display changes as follows: NORMAL (Normal) The selected track is deleted from the program and the next track is displayed. < If you hold down the CLEAR button for more than 3 seconds, all the tracks will be cleared. To add a track to the program While playback is stopped, press the PROGRAM button repeatedly until the program number that you want to insert a track appears on the display. [. . . ]