User manual TEAC 5CD0120A

[. . . ] Construction shall be connected to an AC outlet with a protective grounding connection. This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. [. . . ] < If the remote control unit is operated near other products which generate infrared rays, or if other remote control devices using infrared rays are used near the unit, it may operate incorrectly. Precautions concerning batteries < Be sure to insert the batteries with correct positive "+" and negative "_" polarities. < When the remote control unit is not to be used for a long time (more than a month), remove the batteries from the remote control unit to prevent them from leaking. If they leak, wipe away the liquid inside the battery compartment and replace the batteries with new ones. ENGLISH < Do not heat or disassemble batteries and never dispose of old batteries by throwing them in a fire. Make sure that the batteries are inserted with their positive "+ " and negative "_ " polarities positioned correctly. Battery replacement If the distance required between the remote control unit and main unit decreases, the batteries are exhausted. CAUTION: < Switch off (standby) the power before making connections. < Read the instructions of each component you intend to use with this unit. While in FM mode, tune in an FM station and extend the lead to find the best position for the reception. This antenna may need to be repositioned if you move your unit to a new location. If the iPod that is in playback mode is inserted into the Dock, the SR-L230i will automatically turn on and start playback of the iPod. < If you select "iPod" when no iPod is docked, the iPod indicator on the display blinks. < If you change the volume or source during the muting, the muting will be canceled. Hold down the VOLUME ­ or + button to turn down or up the volume continuously. You can change the bass and treble sound between "­5" to "+5". And then press the VOLUME buttons (­/+) to adjust the sound level within 3 seconds. Each press of the SLEEP button permits setting an interval (from 90 down to 10 minutes). Each press of the SLEEP button changes the time indication by 10 minutes. < If you press the SLEEP button twice, the sleep timer is cancelled. CAUTION Always lower the volume level prior to plugging in your headphones. TO AVOID DAMAGING YOUR HEARING - Do not place your headphones on your head until after you have plugged them in. [. . . ] Or/) for more than 2 seconds and release it when the frequency display begins to change. Stereo FM stereo broadcasts are received in stereo and the "STEREO" indicator lights in the display. < If the sound is distorted and the "STEREO" indicator flashes, the signal is not strong enough for good stereo reception. Press the skip button repeatedly until the station you want to listen to is found. [. . . ]