User manual TEAC 5CD0020A

[. . . ] Construction shall be connected to an AC outlet with a protective grounding connection. < Batteries (battery pack or batteries installed) shall not be exposed to excessive heat such as sunshine, fire or the like. < Excessive sound pressure from earphones and headphones can cause hearing loss. "Made for iPod" means that an electronic accessory has been designed to connect specifically to iPod and has been certified by the developer to meet Apple performance standards. [. . . ] In iPod mode, use this button to turn on or off video output to a connected TV set. After the TIMER ON time is reached, use this button to turn the unit off for 10 minutes. Hold down these buttons for more than 2 seconds to enter the timer setting mode. Note: To simplify explanations, instructions in this manual refer to the names of the buttons and controls on the front panel only. Hold down this button for more than 3 seconds to enter clock setting mode. < Read the instructions of each component you intend to use with this unit. Connect either Connect either one of these cables one of these cables If you want, you can hook the AM antenna on a wall as shown below: Then connect the AC adapter's plug to the AC wall socket. < Do not use any AC adapters other than the one included with this unit to avoid fire, electric shock, etc. Be sure to connect the adapter to an AC outlet that supplies the correct voltage. The battery supplies a backup power to the built-in clock and memory, when the unit is momentarily disconnected from the AC outlet. Battery replacement If the clock comes to indicate the wrong time, replace the battery with a new one. Hold down the VOLUME ­ or + buttons to turn down or up the volume continuously. If the iPod that is in playback mode is inserted into the Dock, the SR-LX5i will automatically turn on and start playback of the iPod. < You can also use the FUNCTION button or Play/Pause button (y/J) to turn the unit on. < If you select "iPod" when no iPod is docked, the iPod indicator on the display blinks. If this button is pressed in standby mode, the display is brightened for about 5 seconds. You can set a sleep timer so the unit turns itself off after a specified time. < If you change the volume or source during the muting, the muting will be canceled. CAUTION Always lower the volume level prior to plugging in your headphones. TO AVOID DAMAGING YOUR HEARING - Do not place your headphones on your head until after you have plugged them in. To switch the bass boost function between high and low, press the DBSS HI/LO button to display the current DBSS level. Then press the button again to switch between "DBSS HI" (high) and "DBSS LO" (low). [. . . ] < If the sound is distorted and the "STEREO" indicator flashes, the signal is not strong enough for good stereo reception. E Use remote control unit within the range (5 m) and point at the remote sensor on the front panel. If normal operation cannot be recovered, unplug the power cord from the outlet and plug it again. If the surface of the unit gets dirty, wipe with a soft cloth or use a diluted mild liquid soap. [. . . ]