User manual TASCAM CD-RW750 QUICK START

[. . . ] D00808400A » CD-RW750 --Quick Start Guide Viewing CD TEXT The CD-RW750 can display disc and track titles of finalized CDs that contain such information. The way that titles are displayed is as follows: Disc titles These may be up to 23 characters long. [. . . ] As well as allowing you to view the elapsed disc and track times, and the remaining disc and track times, the DISPLAY key can also be used to display the track titles on a finalized disc. In this case, if a track title contains more than 12 characters , the track title is scrolled across the display. Entering CD TEXT The CD-RW750 allows CD TEXT to be entered on unfinalized discs prior to finalization. Note that not every player is capable of reading and displaying CD TEXT. 2 Press the MULTI JOG control. T_EDIT>DISC? 3 Press the MULTI JOG control to start entering the disc title (or editing it if it exists). See the next page for details of how to enter and edit title text. 1 With playback stopped, press the MENU key until the display shows: CD TEXT? Track titles 4 Turn the MULTI JOG control. The display shows: T_EDIT>01 T r the track whose title is to be edited is shown. 6 Press the MULTI JOG control to start entering the track title. Otherwise enter the title text as described below. 5 Continue turning the MULTI JOG control (if necessary) until the number of All titles 7 Press FINALIZE/YES to finish editing the current title. The display shows Writing where XXX is the current track number (or DISC if the disc title has just been edited). 8 Turn and press the MULTI JOG to select and edit further titles. followed by Write OK 9 When all titles have been edited, press STOP to end editing. followed by T_EDIT>XX T r 10 Fina lize the disc (see the main manual). Discs which are not finalized and are then ejected (or are loaded and the power is then turned off) will lose their titles. Editing text · Pushing the FADER/JOG MODE key toggles between the character entry mode and the cursor movement mode. Character Entry: When the underline cursor is flashing, turning the MULTI JOG control cycles through the alphanumeric characters available for titling. · Cursor movement: When the underline cursor is lit steadily, turning the MULTI JOG control moves the cursor left or right. Change between uppercase (capital) letters and lowercase letters with the DISPLAY key (when you are inputting uppercase letters, the display shows CAPS). · · · 2 Synchronized recording Synchronized recording with the CD-RW750 provides you with an easy way to record both analog and digital program material, starting tracks at the beginning of the material, and ending them automatically when it finishes. Two synchronization modes are available: SYNC ALL, for repeated recording of many tracks one after the other, and SYNC 1, for recording one track only. The steps necessary to record using this facility are as follows: 1 With a recordable disc loaded, select the input source. 2 Set the threshold level which allows triggering of the sync mode. 3 Adjust the input level (if necessary). [. . . ] Level falls below trigger level for less than six seconds and then rises above trigger level or level falls below trigger for six seconds or more Stop conditions Level falls below trigger level for six (all inputs) seconds or more Enter record ready 1 Simply press the RECORD key and the unit enters record ready mode. Start playback of the source Start playback of the source a little before where you want the recording to begin. The CD-RW750 enters record mode automatically depending on the source type, as explained earlier, and stops recording automatically, depending on the synchronization mode. TEAC CORPORATION Phone: +81-422-52-5082 3-7-3, Nakacho, Musashino-shi, Tokyo 180-8550, Japan www. tascam. com Printed in China [. . . ]