User manual TASCAM CD-450

[. . . ] This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the instruction manual, may cause harmful interference to radio communications. Operation of this equipment in a residental area is likely to cause harmful interference in which case the user will be required to correct the interference at his own expense. CAUTION Changes or modifications to this equipment not expressly approved by TEAC CORPORATION for compliance could void the user's authority to operate this equipment. IMPORTANT: DO NOT make any connection to the larger terminal which is marked with the letter E or by the safety earth symbol ç or coloured GREEN or GREEN-and-YELLOW. The wires in the mains lead on this product are coloured in accordance with the following code: BLUE BROWN : NEUTRAL : LIVE For the consumers in Europe WARNING This is a Class A product. [. . . ] 18) Object and Liquid Entry -- Never push objects of any kind into this product through openings as they may touch dangerous voltage points or short-out parts that could result in a fire or electric shock. 19) Servicing -- Do not attempt to service this product yourself as opening or removing covers may expose you to dangerous voltage or other hazards. 20) Damage Requiring Service -- Unplug this product from the wall outlet and refer servicing to qualified service personnel under the following conditions: a) when the power-supply cord or plug is damaged. b) if liquid has been spilled, or objects have fallen into the product. d) if the product does not operate normally by following the operating instructions. Adjust only those controls that are covered by the operating instructions as an improper adjustment of other controls may result in damage and will often require extensive work by a qualified technician to restore the product to its normal operation. f ) when the product exhibits a distinct change in performance ­ this indicates a need for service. 21) Replacement Parts -- When replacement parts are required, be sure the service technician has used replacement parts specified by the manufacturer or have the same characteristics as the original part. Unauthorized substitutions may result in fire, electric shock, or other hazards. 22) Safety Check -- Upon completion of any service or repairs to this product, ask the service technician to perform safety checks to determine that the product is in proper operating condition. 23) Wall or Ceiling Mounting -- The product should be mounted to a wall or ceiling only as recommended by the manufacturer. 24) Heat -- The product should be situated away from heat sources such as radiators, heat registers, stoves, or other products (including amplifiers) that produce heat. TASCAM CD-450 3 SAFETY INFORMATION This product has been designed and manufactured according to FDA regulations "title 21, CFR, chapter 1, subchapter J, based on the Radiation Control for Health and Safety Act of 1968", and is classified as a class 1 laser product. There is no hazardous invisible laser radiation during operation because invisible laser radiation emitted inside of this product is completely confined in the protective housings. - USE OF CONTROLS OR ADJUSTMENTS OR PERFORMANCE OF PROCEDURES OTHER THAN THOSE SPECIFIED HEREIN MAY RESULT IN HAZARDOUS RADIATION EXPOSURE. Do not drop this unit or subject it to severe impact. Internal circuits or the enclosure may be damaged. . . . Place this unit on horizontal and solid surfaces. There is a risk this unit overturns if installed on unstable shelves or stands. . . . To remove severe dirt, wipe it off with a soft cloth lightly moistened with neutral detergent and water. Never use any type of solvents such as benzine and thinner, which would damage the coating or erase legends. TASCAM CD-450 5 Specifications Disc: Audio channel: Quantization: Sampling frequency: Analog output level Line output (RCA) Nominal output level: 8-cm/12-cm CD 2 channels 16-bit linear 44. 1 kHz Power requirements: 120 V AC, 60 Hz (U. S. A. /Canada model) 230 V AC, 50 Hz (Europe/U. K. model) 240 V AC, 50 Hz (Australia model) Power consumption: 16 Watts External dimensions: 482 x 104. 5 x 310 mm Weight: 5. 1 kg Typical Performance Frequency response: Signal-to-Noise Ratio: Distortion: Channel separation: Pitch control: Auto cue level: ­10 dBv (load impedance 10kOhms, unbalanced) Maximum output level: +6 dBv (2Vrms) Line output (XLR) [Optional LA-450] Nominal output level: +4dBu (load impedance 10kOhms, balanced) Maximum output level: +20 dBu Headphone output (standard stereo phone jack): 25 mW at max. (load impedance 32Ohms) Digital output Coaxial (RCA): 20 Hz to 20 kHz (+/-1 dB) Better than 90 dB Less than 0. 006% Better than 85 dB Within +/-12% (1% steps) ­72/­66/­60/­54 dB IEC60958 home-use (SPDIF) Balanced (XLR) [Optional LA-450] : IEC60958 broadcasting studios (AES/EBU) * Changes in specifications and features may be made without notice or obligation. External Dimensions 6 TASCAM CD-450 General Guide 1 POWER Switch 2 Headphone Volume Control (PHONES) 3 Headphone Jack 4 Disc Tray 5 Numeric Keypad This is used to enter tack numbers, index numbers and time points. E PLAY Key F READY Key This key puts the deck into Ready-for-play mode. G CALL Key The point where you press PLAY to leave the ready mode and start playing is stored in memory, and you can go back to that point by pressing this CALL key. H AUTO READY Key When this key is pressed on, the deck goes into Ready mode at the beginning of each tack or at the beginning of an A-B loop. 6 CLEAR Key This key is used to clear wrong numbers you'll enter on the numeric keypad or to clear all your preference settings (p. 9) at once. I AUTO CUE Key When this key is pressed on and you perform a track search, the deck goes into Ready mode at the "first audio" of that track. ®Preference Settings, p. 9 7 Disc Tray OPEN/CLOSE Button 8 SEARCH MODE Key Three search modes are available: Track, Time, and Index, as selected with this switch. ®Search Operations, p. 9 J INCR (Incremental) PLAY Key When this key is pressed on, each time you press PLAY during play, the next track starts playing. [. . . ] DISPLAY mode (ELAPSED, REMAIN, or TOTAL Event Start You can let this deck start playing by inputing a one-shot pulse signal from the exterior or by shortcircuiting between the tip and sleeve of a stereo phone plug connected to the FADER/EVENT START jack. RING +5V GND 50 ms or more TIP SLEEVE TIP SLEEVE RING FADER/EVENT START connector REMAIN) . . . If you fail to observe this caution, you should prepare to accept responsibility for all consequences. TASCAM CD-450 11 » CD-450 TEAC CORPORATION Phone: (0422) 52-5082 Phone: (213) 726-0303 3-7-3, Nakacho, Musashino-shi, Tokyo 180-8550, Japan 7733 Telegraph Road, Montebello, California 90640 5939 Wallace Street, Mississauga, Ontario L4Z 1Z8, Canada Privada De Corina, No. 18, Colonia Del Carmen Coyoacon, Mexico DF 04100 5 Marlin House, Marlins Meadow, The Croxley Centre, Watford, Herts. Bahnstrasse 12, 65205 Wiesbaden-Erbenheim, Germany 17 Rue Alexis-de-Tocqueville, CE 005 92182 Antony Cedex, France P. A. TEAC Nederland BV, Perkinsbaan 11a, 3439 ND Nieuwegein, Netherlands Perkinsbaan 11a, 3439 ND Nieuwegein, Netherlands 106 Bay Street, Port Melbourne, Victoria 3207, Australia Via C. [. . . ]