User manual TASCAM 322 QUICK START

[. . . ] 322 Quick Start guide This Quick Start Guide is intended to help you use some of the functions of the 322 which may be unfamiliar to you. Dubbing between decks 1 and 2 The 322 allows you to copy material between its two decks at either normal or high speed (double speed). 1 2 4 56 7 1 Load the source cassette into Deck 1 and the target into deck 2. Use the PHONES control, switching between 1 and 2 as appropriate to help you. [. . . ] 2 Ensure that the REV MODE switch is set to CONT (continuous playback). 3 Load a tape into both decks. Select the appropriate Dolby setting for each deck. 4 Press PLAY on Deck 1. Playback starts at the start of Deck 1's tape and goes on to the end. Reverse playback then continues from the end of Deck 1's tape, to the start of the tape. Playback then starts at the start of Deck 2's tape and goes on to the end. Reverse playback continues from the end of Deck 2's tape, to the start of the tape. 5 Press STOP (either Deck 1 or Deck 2) to stop the continuous playback. 322 Quick Start guide Recording on both decks at the same time Another useful feature of the 322 is ability of both decks to record at the same time from a single source or sequential recording from a single source. The instructions below tell you how to record the same program on two tapes at the same time. 1 2 53 8 64 8 7 1 Connect the source to the DECK 1 INPUT connectors. Insert the tapes into the decks. 2 Press the RESET buttons to record the "zero" start time. 3 Select recording on either one side (Ä) or both (ä) side of the tapes, using the REV MODE switch. 4 Set the INPUT/OUTPUT switch to COMMON. 8 Stop recording with the STOP key of either deck. 322 Quick Start guide Dubbing using two 322 units This example shows how to "cascade" two 322 units and produce copies from the master 322 in the chain. MASTER SLAVE 1 2 3 4 6 5 1 Connect the 322 units as shown. The master unit in this picture is on top, and the master's CASCADE OUTPUTs should be connected to the slave's DECK 1 INPUTs. [. . . ] Select high-speed or normal speed dubbing with the master unit's DUB STDBY NORM or HIGH SPEED buttons. Playback starts on the master's Deck 1 and recording starts on all other decks. 6 Press the master Deck 2 STOP to stop the dubbing. TEAC CORPORATION Phone: (0422) 52-50823-7-3, Nakacho, Musashino-shi, Tokyo 180-8550, Japan [. . . ]