User manual TARGUS USB NOTEBOOK MOUSE INTERNET PHONE

[. . . ] To use the parallel printer cable, you must first install its driver software onto your computer if it has Windows® 98 / ME as the operating system. 2 If setup does not begin automatically, click Start, Run, then enter D:\Setup. To do this, plug the standard USB end of the cable into an available USB port to your computer. [. . . ] To do this, plug the standard USB end of the cable into an available USB port to your computer. You may be prompted to install one or more of the hardware drivers: To install the drivers: 1 Select Install the software (Recommended) and click Next. 2 Follow any on-screen instructions and repeat as needed for each device. 2 Install the printer software driver according tot he instructions that come with the device. If this port does not appear in the list, choose the LPT1 port, complete the manufacturer's setup for your printer, and refer to the instructions below to redirect your printer. Checking and Redirecting the Printer Port Settings Follow these instructions to check the printer port settings and redirect your printer from the LPT 1 port to the USB001 (USB port) on the adapter. Disconnect the adapter from your computer's USB port, then reconnect it. This warranty does not cover accidental damage, wear and tear, or consequential or incidental loss. Under no conditions is Targus liable for loss of, or damage to a computer; nor loss of, or damage to, programs, records, or data; nor any consequential or incidental damages, even if Targus has been informed of their possibility. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) This device must accept any interference received, including interference that may cause undesired operation. This equipment has been tested and found to comply with the limits of a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses, and can radiate radio frequency energy and if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. [. . . ] This equipment generates, uses, and can radiate radio frequency energy and if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures: · Connect the equipment into an outlet on a circuit different from that to which the receiver is connected; · consult the dealer or an experienced radio/TV technician for help. [. . . ]