User manual TARGUS BLUETOOTH COMFORT LASER MOUSE

[. . . ] All trademarks and registered trademarks are the property of their respective owners. Remove the battery cover from the top of the mouse by using the notch on the back. [. . . ] Battery Check: After the mouse is turned on, quickly press and release the power button. The battery life indicator will light up showing the current power level of the batteries. Power Saving mode: After an extended period of time, if the mouse is not used, it will automatically enter power saving mode to conserve power and increase battery life. 3 LEDs lit 2 LEDs lit 1 LED lit Full power Half power Low power Enable Discovery mode: The mouse will go into pairing mode automatically after it is powered on. the 1st and 3rd LEDs will flash alternately for 60 seconds; this indicates that the pairing sequence is in operation. Once the connection is established, the 1st and 3rd LED lights will light up steadily for 3 seconds. To extend the life of your battery, turn off the mouse while travelling or when you're not using it. If the connection is not established by the end of 60 seconds, the mouse will go into sleep mode. Before you can begin using your Bluetooth mouse, you will first need to perform some initial setup steps. Go to the Bluetooth Places icon located on your desktop or in the system tray and double click, then click Add a Bluetooth Device. [. . . ] Paired devices are always displayed in My Bluetooth Places, even if the mouse is out of range or not powered up. Gå till den plats där Bluetooth ikonerna är placerade på ditt skrivbord eller i aktivitetsfältet för systemet och dubbelklicka, klicka sedan på Lägg till en Bluetooth enhet. [. . . ]