User manual TARGUS AMU4501 SAFETY GUIDE

[. . . ] Please contact the nearest Miele dealer or the Miele Technical Service Department with specific requirements. This steam oven is designed for installation in cabinetry or beneath a counter top. This is necessary to ensure that all electrical components are shielded. [. . . ] Be certain your appliance is properly installed and grounded by a qualified technician. To guarantee the electrical safety of this appliance, continuity must exist between the appliance and an effective grounding system. If there is any doubt, have the electrical system of the house checked by a qualified electrician. The manufacturer cannot be held responsible for damage caused by the lack, or inadequacy of, an effective grounding system. Do not tamper with electrical connections and components or mechanical parts. Never open the outer casing of the appliance. 3 instructions before installation or use of the steam oven to prevent injury and machine damage. Before installation make sure that the voltage and frequency listed on the data plate correspond with the household electrical supply. The steam oven should be supported by a shelf or ledges. 23 68m m) 3 8 2 3 8" (593-595mm) (56 0 " - 23 716 22 m) m 1 16 " c 7 7 Installing the oven Securing the oven After aligning the oven it must be secured in position. Open the oven door and using the supplied screws g, secure it to the cabinet through the holes on either side of the vertical oven trim. 8 Installing the oven Electrical connection Disconnect main power supply before servicing. To reduce the risk of electrical shock, make sure that the appliance is properly grounded after installation. All electrical work should be performed by a licensed electrician, in strict accordance with national and local safety regulations and standards. ­ Note to installer: Please leave these instructions with the consumer. ­ Power supply: Please check the data plate: 240 VAC; 60 Hz 15A, 240 V L1, L2, Ground Make sure your electrical supply matches the data plate. For USA only The appliance is provided with 3 terminal leads: 1 black wire (L1), 1 red wire (L 2) and 1 green wire (GND) that must be connected to a dedicated junction box. [. . . ] ­ Power supply: Please check the data plate: 240 VAC; 60 Hz 15A, 240 V L1, L2, Ground Make sure your electrical supply matches the data plate. For USA only The appliance is provided with 3 terminal leads: 1 black wire (L1), 1 red wire (L 2) and 1 green wire (GND) that must be connected to a dedicated junction box. Connect the black wire to L1, the red wire to L2 and the green wire to GND. [. . . ]