User manual TAG HEUER 2000 AQUAGRAPH

[. . . ] In addition, your TAG Heuer has been individually tested to guarantee its water-resistance and perfect running. The international warranty card of your TAG Heuer watch is recognized by all TAG Heuer Service Centres in over 110 countries worldwide. The TAG Heuer SA international warranty is valid only if the serial number engraved on the watchcase is perfectly legible and no part of the original case back or original number has been removed, changed, falsified, replaced, erased or rendered illegible. Failure to comply with these conditions invalidates all rights under the TAG Heuer SA international warranty system. [. . . ] Even if a drop of water were to penetrate inside the case, the Calibre 60 would continue to function because it is mechanical. One particularly important and unique feature of the TAG Heuer Calibre 60 is the central position of the chronograph minutes hand on the dial instead of in a counter as on a traditional chronograph. This permits clear and immediate reading of this information which is essential to measure the duration of the decompression stages. Secure unidirectional turning bezel The unidirectional turning bezel of your TAG Heuer 2000 Aquagraph, fitted with precision stop pawls, enables you to measure your diving time precisely. The catches on of the rotating bezel make it easy to operate, even when wearing thick diving gloves. For still greater security, the TAG Heuer 2000 Aquagraph is fitted with a unique system which keeps the bezel locked at all times. Pressure must be exerted on the base of the bezel to make it rotate (fig. When this pressure ceases, the bezel will automatically lock in its current position. When you start your dive, set the zero marker on the bezel against the minutes hand (fig. 2 Setting the time At every moment, the position of the minutes hand on the bezel will indicate the number of minutes which have elapsed since the start of the dive (fig. 3 Your TAG Heuer 2000 Aquagraph is fitted with a screw-in crown with safety gaskets which guarantee its water-resistance to a depth of 500 m. 3: crown released and pulled out to position 3: the hour and minutes can be set on the main dial and 24h indicator. The 24h indicator shows whether the time displayed on the main dial is AM or PM. fig. 4 0-1 2 3 9 30 minutes have elapsed since the start of the dive Chronometer functions For example, if the hours and minutes hands on the main dial read 10. 10, the 24h indicator shows whether the time is 10. 10 AM (fig. The time shown on the 24h indicator is adjusted as a function of the hour and minute hands on the main dial. Important: the crown must be screwed back in correctly to guarantee waterresistance of the timepiece. If a coloured ring can be seen on the crown, this indicates that the latter has not been screwed in correctly. fig. 5 The chronometer functions are actuated by pressing the push-pieces. The unique feature of the TAG Heuer Calibre 60 is to permit clear and immediate reading of the chronograph minutes; this information is vital to measure the duration of the decompression stages. If necessary, use push-piece B to effect a zero reset. 11 10h10 AM = 10h10 1. > 3. 10h10 PM = 22h10 Start: End: Read the time Zero reset: push-piece A (START) push-piece A (STOP) push-piece B Automatic helium escapement valve 2. [. . . ] Proceed in the same way with the second pin; then press the case attachment so that the bar pins notch into the holes provided for them. * For owners of the diving kit Case attachment Bar Bracelet Tool Pin Horn fig. 8 Important: Always make sure that the two bar pins are correctly fitted. The section of the bracelet with the diver's extension must always be positioned on the 12 o'clock side (fig. [. . . ]