User manual SYNQ AUDIO RESEARCH SUPER SOLAR RGBW V1.0

[. . . ] Condense sometimes prevents the unit from working at full performance or may even cause damages. No objects filled with liquids, such as vases, shall be placed on this appliance. If a foreign object enters the unit, immediately disconnect the mains power. No naked flame sources, such as lighted candles, should be placed on the appliance. [. . . ] Output as long as the button is pressed) Scene mode: CHANNEL fader closed switch the programmed scene on/off. (set scene at 100%) Remark: in both working modes MIDI data (note on/off) is sent through the USB-output (10) 3. STATUS LED: information depends on the working mode: Manual mode: lights up progressively, depending on the fader position. Blinking while a scene is programmed and active (shown on the output) 4. SCENE/MANUAL BUTTON: used to toggle between manual mode and scene mode: Manual mode: each of the 16 CHANNEL faders can be used to manually set the output level. Scene mode: each of the 16 CHANNEL faders can contain a scene, scenes can be mixed manually. While pressed together with the DISPLAY MODE button (6), you can set the controller in MIDI RECEIVE mode, see chapter "HOW TO USE" for more information. LED DISPLAY: shows different information, depending on the working mode and/or display mode. DISPLAY MODE BUTTON: press the button to browse the different display modes: Display mode 1: (led off) shows the DMX-values while a CHANNEL fader is moved (000 to 512). Display mode 2: (led off) shows the output in % while a CHANNEL fader is moved (0% to 100%). Display mode 3: (led on) shows the MIDI-values while a CHANNEL fader is moved (000 to 127). Use the CHANNEL faders (1) and FLASH buttons (2) to create the desired output. remark: use the DISPLAY button (6) to show the desired DMX-values on the display (0-512 or 0-100%). USE IN SCENE MODE A scene is a combination of different fader positions, this scene can be programmed under one fader. Moving this fader up while the controller is set to scene mode will recall all these different fader positions in one time. Two ways to recall scenes: Use the CHANNEL faders (1) to recall the saved scenes gradually (0-100%). Once a CHANNEL fader is moved up a little, you can use the corresponding FLASH button (2) to set the scene instantly at 100%. When you release the FLASH button, the scene goes back to the output you have set with the CHANNEL fader. Scenes can only be programmed while the unit is set in "program mode". So first enter "program mode" by pressing the SCENE/MANUAL (4) and PROGRAM (8) buttons together red "program LED" is lit. Press the PROGRAM button (8) to check which channel faders already have scenes programmed: Channel with NO scene programmed: the STATUS LED (3) of this channel is dark. Channel with scene programmed: the STATUS LED (3) of this channel is lit. [. . . ] DELETE SCENES Any programmed scene overwritten by a new scene or deleted. Only the BLACKOUT-button (9) is still active: Press the BLACKOUT-button shortly: DMX-output goes in blackout but scenes are still active. press the BLACKOUT-button for 2 seconds: all scenes are switched off. (in case something goes wrong in the MIDI-communication) MIDI COMMANDS Switching scenes on/off: Fading scenes gradually: Blackout function: Remark: "n" = MIDI channel. [. . . ]