User manual SYNQ AUDIO RESEARCH SMP 8.2 V1.0

[. . . ] No naked flame sources, such as lighted candles, should be placed on the appliance. Don't cover any ventilation openings as this may result in overheating. minimum distances around the apparatus for sufficient ventilation is 5cm. Always unplug the unit when it is not used for a longer time or before you start servicing. [. . . ] If a PAN control is set all the way to the left, for example, the sound from that channel will be heard from the left speaker system only. If it is set all the way to the right, the sound will be heard from the right speaker system only. Intermediate settings will cause the sound to appear at corresponding locations in the stereo sound field. bALANCE (Stereo Channel) This control adjusts the balance or the L/R position of the stereo input signal. Turning the BALANCE control to the left of center moves the apparent source toward the MAIN MIX L bus, turning it to the right moves the source toward the MAIN MIX R bus. It determines the level of the signal that is sent from the channel to the master mixing effect bus. It is the settings of the input channel volume knobs that determine the mix, or the balance of sound levels between the instruments or other sources connected to the inputs. When a channel is not being used, its volume knob should be set at the minimum position to prevent the addition of unwanted noise to the main program signal. PEAK LED INDICATOR This LED indicator shows the level of the signal input of the channel. The peak indicator lights up when the input signal reaches 5dB below the channel's clipping point. If the PEAK indicator lights more than briefly on high-level transients, you should use the TRIM control to decrease the input sensitivity of the channel. If this does not work, reduce the output level of the connected source. TRIM CONTROL According to the level of the input signal, use this knob to adjust the input to an appropriate level. The best balance of S/N and dynamic range will be achieved if you adjust the TRIM control so that the peak indicator lights occasionally. This control adjusts the channel's MIC input sensitivity between -50dB and -6dB and the line input sensitivity between -30dB and +14dB. EFX RTN VOLUME KNOB Adjust the level of the signal sent from the internal digital effect to the MAIN bus. AUX STEREO RETURN CONTROL Adjusts the level of the signal coming from the AUX RETURN connectors (L and R), routed to the MAIN L/R bus. TAPE IN CONTROL This knob controls the level of the playback signal that is coming from the TAPE IN RCA connectors, and that will be routed to the MAIN L/R output. LEVEL METER This LED display shows the level of the MAIN L/R output signal. CHANNEL INPUTS BALANCED MIC XLR Connectors These are balanced XLR-type input jacks (1: Sleeve, 2: Hot, 3:Cold) BALANCED LINE IN JACK Connectors A standard 1/4" TRS phone jack is used for balanced or unbalanced line level signals, like used with most electronic keyboards, synthesizers, tape decks and the line outputs from other mixers. CHANNEL INSERT I/O JACK These are input/output jacks located between the head-amplifier and the high pass filter. These jacks can be used to independently connect these channels to devices such as graphic equalizers, compressors, and noise filters. [. . . ] 66dB MIC IN TO MAIN L/R 60dB MIC IN TO AUX 66dB MIC IN TO EFX 76dB MIC IN TO CONTROL ROOM L/R 58. 2dB IN TO REC L/R 46dB LINE IN TO MAIN L/R 46dB LINE IN TO AUX 46dB LINE IN TO EFX 56dB LINE IN TO CONTROL ROOM L/R 36dB STEREO IN TO MAIN L/R 6dB AUX RETURN IN TO MAIN L/R 16dB TAPE IN TO MAIN L/R -70dB between input channels -70dB between input/oputput channels 44dB Variable (-50dB ~ -6dB) (-30dB ~ +14dB) 40dB Variable (-20dB ~ +20dB) HIGH: 12kHz shelving MID: 2. 5kHz peaking LOW: 80Hz shelving *Turnover/roll off frequencies: located 3dB below max. Boost/cut 2x 10 segment LED for MAIN L/R 100 selectable presets FOOT Switch control (ON/OFF) Peak: an indicator for each channel turns on when the pré-channel fader signal is 5dB below clipping +48V DC 2, 8 kg 249(W) x 75(H) x 295(D) mm Every information is subject to change without prior notice You can download the latest version of this user manual on our website: www. [. . . ]