User manual SYNQ AUDIO RESEARCH MINI DMX SPLITTER V1.0

[. . . ] conformity has been established and the relevant statements and documents have been deposited by the manufacturer. The perfect solution for many DMX-line problems: this mini DMX-splitter divides any DMX-chain in 2 separate lines that will not interfere with each other, problems on 1 line will not influence the other line!Booster function makes your DMX-installation more reliable and flexible to set up. [. . . ] If a foreign object enters the unit, immediately disconnect the mains power. No naked flame sources, such as lighted candles, should be placed on the appliance. Always unplug the unit when it is not used for a longer time or before you start servicing. The electrical installation should be carried out by qualified personal only, according to the regulations for electrical and mechanical safety in your country. Check that the available voltage is not higher than the one stated on the rear panel of the unit. The socket inlet shall remain operable for disconnection from the mains. The power cord should always be in perfect condition: switch the unit immediately off when the power cord is squashed or damaged. It must be replaced by the manufacturer, its service agent or similarly qualified persons in order to avoid a hazard Never let the power-cord come into contact with other cables!In order to avoid a hazard, the unit shall only be used with the AC-adaptor delivered with it. In the event of serious operating problems, stop using the appliance and contact your dealer immediately. Due to safety reasons it is prohibited to make unauthorized modifications to the unit. Do not use volatile liquids such as benzene or thinner which will damage the unit. CAUTION: To reduce the risk of electric shock, do not remove the top cover. POWER INDICATOR: The indicator LED lights when the receiver is ready to operate. Simply connect this output to the next DMXunit in this extra DMX-line. The lightning flash with arrowhead symbol within the equilateral triangle is intended to alert the use or the presence of un-insulated "dangerous voltage" within the product's enclosure that may be of sufficient magnitude to constitute a risk of electric shock. [. . . ] However the new JB Systems "1Ch DMX Master/slave" system preserves the unique master/slave function, you can even control it by an external DMX-controller!To be able to use this feature you need the "Mini DMX-SPLITTER", as shown in the setup below: LINE 2 is the secondary DMX-line where the effects can be connected in Master/slave: the master will be controlled by the DMX-controller; the slaves will be controlled by the master. AC/DC Power adapter: DMX in/outputs: DMX-Isolation: Size: Weight: AC 100-240V 50/60Hz 9Vdc / 0, 8A 3pin XLR protection against faulty DMX-signals on in/out, no overvoltage protection 102 x 72 x 39, 4 mm 0, 24 kg (including power adapter) Every information is subject to change without prior notice You can download the latest version of this user manual on our website: www. [. . . ]