User manual SYNQ AUDIO RESEARCH LS-WH-DMX CONTROL V1.0

[. . . ] The electrical installation should be carried out by qualified personal only, according to the regulations for electrical and mechanical safety in your country. Check that the available voltage is not higher than the one stated on the rear panel of the unit. The socket inlet shall remain operable for disconnection from the mains. Switch the unit immediately off when the power cord is squashed or damaged. [. . . ] Do not use volatile liquids such as benzene or thinner which will damage the unit. The following table shows the EQ type, frequency, and maximum cut/boost for each of the three bands. For more information on connections, please refer to the next chapter. Be sure to turn off the mixer before you make changes to the different connections. If you are using stereo channels, the signals from the L and R channels are mixed and send to the AUX bus. Pré-fader aux outputs are not influenced by the position of the channel fader and are mainly used to control stage monitors. This knob controls the level of the signals sent to the EFX bus (to the EFX SEND jack on the front panel and to the internal effect module). The channel signals mixed by this bus have their overall level set by the EFX SEND Control. Since this control is placed after the channel fader, the signal level will be affected by the channel fader's setting. PAN /BAL CONTROL PAN (Mono Channel) This control pans the channel signal across the master L and R busses, thus determining the perceived position of the sound from that channel in the output stereo sound field. If a PAN control is set all the way to the left, for example, the sound from that channel will be heard from the left speaker system only. If you set the switch on, the mixer supplies power to all channels that provide XLR MIC inputs. Set this switch on when using one or more condenser microphones that need to receive external power from the mixer. NOTE: When this switch is on, the mixer supplies DC +48V power to pins 2 and 3 of all XLR-type MIC INPUTS. * Be sure to leave this switch off ( ) if you do not need phantom power. * When tuning the switch on ( ), be sure that only condenser MICs are connected to the XLR input jacks. Devices other than condenser MICs may be damaged if connected to the phantom power supply. Note, however, that the switch may be left on without problem when connecting to balanced dynamic microphones. * To avoid damage to speakers, be sure to turn off amplifier (on powered speakers) before turning this switch on or off. We also recommend that you turn all out controls to minimum settings before operating the switch, to avoid risk of loud noises that could cause hearing loss or device damage. PHANTOM POWER INDICATOR This indicator lights up when the phantom power is switched on. CHANNEL INPUT JACKS These are unbalanced stereo line input connectors. [. . . ] This means also you will be able to use the standard audio interface controls in the MAC or Windows operating system to make all the settings. Getting Started with Windows XP The first time you plug the mixer into a USB port, Windows will install the universal drivers for that port. A balloon tip will pop up, telling you it has found the USB Audio codec. When the installation is ready, the message "Your new hardware is installed and ready to use" will appear Most of the time, you'll want the output volume from the computer at it's maximum position, but sometimes the default setting is much lower, what makes the output level too low. [. . . ]