User manual SYNQ AUDIO RESEARCH LED CROSSFIRE V1.0

[. . . ] Die direkte Sonneneinstrahlung kann das Gerät zerstören oder zum brennen bringen!¡nunca exponga la lente a la luz solar directa, aún durante un período corto!¡Esto puede dañar el efecto de luz o incluso causar el fuego!Nunca exponha as lentes directamente à luz solar, mesmo que por pouco tempo! [. . . ] The device should be well fixed; a free-swinging mounting is dangerous and may not be considered! Don't cover any ventilation openings as this may result in overheating. The operator has to make sure that the safety-relating and machine-technical installations are approved by an expert before using them for the first time. The installations should be inspected every year by a skilled person to be sure that safety is still optimal. SETUP MENU: Before you can operate the unit properly, you should set the right configuration via the setup menu. To select any of the functions, press the MENU button up to when the required one is shown on the display or use the DOWN and UP buttons to browse the menu. Once the required mode is selected, press the ENTER button to confirm. To go back to the main menu without any change press the MENU button shortly. Press the MENU button until "DMX Address" is shown on the display. Once the correct address shows on the display, press the ENTER button to save it. To go back to the main menu without any change press the MENU button shortly. If you want to go back to normal running mode: press the MENU button for about 2 seconds. You will be asked the amount of units that are linked in master/slave: set the number of linked units, including the master. You will be asked which preprogrammed show you want to use: choose from 1-1 to 1-8. (Note that this setting is only relevant while used without any controller, you can change the speed using the menu buttons on the master) You will be asked which playback speed you want for the show: choose from 0 to 255. Use DOWN and UP button to select a value between "0" (very low sensitivity) and "100" (high sensitivity). To go back to the main menu without any change press the MENU button shortly. If you want to go back to normal running mode: press the MENU button for about 2 seconds. Blackout Mode Blackout mode: when no DMX-signal is detected, the unit goes in blackout and waits for a DMXsignal. No blackout mode: when no DMX-signal is detected, the unit automatically switches to standalone mode. Press the MENU button until "Black Out" is shown on the display. Use DOWN and UP button to select "Yes" (blackout on) or "No" (blackout off) mode. To go back to the main menu without any change press the MENU button shortly. If you want to go back to normal running mode: press the MENU button for about 2 seconds. [. . . ] Connect 2 to maximum 999 units together using good quality balanced microphone cables. The first unit in the chain will act as the master, the other units will act automatically as slaves. For the DMX-controller the master and his slaves can now be considered as 1 virtual effect that needs a start address so it can be controlled as any other DMX-unit in the DMX chain: see "DMX Address" in the chapter "Main Menu" to see how you can set the DMX-start address. Remark: in order to work well to the rhythm of the music, make sure that the option "Sound State" on the master is set to "On" (see previous chapter) Electrical installation in DMX-mode: The DMX-protocol is a widely used high speed signal to control intelligent light equipment. [. . . ]