User manual SYNQ AUDIO RESEARCH DIGIT 3K6 V3.0

[. . . ] Extremely high power output: o Digit 1K0: 2x 540Wrms @ 4ohms o Digit 2K2: 2x 1100Wrms @ 4ohms o Digit 3K6: 2x 1800Wrms @ 4ohms Output in bridge mode: o Digit 1K0: 1080Wrms @ 8ohms o Digit 2K2: 2200Wrms @ 8ohms o Digit 3K6: 3600Wrms @ 8ohms All the protections you can think of for professional use: o Signal + current limiters o Overload protection o Short circuit current protection o DC protection o Thermal protection o AC, VHF protection o Soft start o. Switchable 30Hz low cut filter eliminates unwanted, power consuming, subsonic frequencies. 3 different working modes: stereo, bridge mode, mono mode (inputs linked) Input sensitivity: 26 dB / 32 dB / 1, 4 V Balanced in/outputs on XLR 2 Speakon connectors (left and right outputs) 1 separate output for bridge mode The lightning flash with arrowhead symbol within the equilateral triangle is intended to alert the use or the presence of un-insulated "dangerous voltage" within the product's enclosure that may be of sufficient magnitude to constitute a risk of electric shock. [. . . ] It is absolutely necessary for the user to strictly follow the safety instructions and warnings in this user manual. The dealer will not accept responsibility for any resulting defects or problems caused by disregarding this user manual. To protect the environment, please try to recycle the packing material as much as possible. INSTALLATION GUIDELINES: Install the unit in a well-ventilated location where it will not be exposed to high temperatures or humidity. Placing and using the unit for long periods near heat-generating sources such as amplifiers, spotlights, etc. (screws not provided) Take care to minimize shocks and vibrations during transport. When installed in a booth or flight case, please make sure to have good ventilation to improve heat evacuation of the unit. To avoid condensation to be formed inside, allow the unit to adapt to the surrounding temperatures when bringing it into a warm room after transport. Condense sometimes prevents the unit from working at full performance. CLEANING THE APPLIANCE: Clean by wiping with a polished cloth slightly dipped with water. Do not use volatile liquids such as benzene or thinner which will damage the unit. In the description of the unit you will find more information on how to connect the amplifier. Switch (14) on the rear panel is used to choose one of these 3 possible modes: STEREO MODE: Both LEDs are off. Basically this is identical to stereo mode but the inputs of both channels are linked so the output will be mono. In this case you only need to use the input of the left channel to drive both output channels. Both channels are linked in "bridge mode" to obtain a mono output with much higher power. SIGNAL LEDS: these LEDs indicate that a music signal is present at the inputs. CLIP LEDS: The LEDs will light up in the following situations: When the output signal has reached a high level which can result in distortion (clipping). [. . . ] In mono mode you only have to connect the left input to drive both outputs. INPUT SENSITIVITY SWITCH: you can choose 3 different input levels: 26 dB / 32 dB / 1, 4 V 16. BALANCED XLR OUTPUTS: Can be used to send the signal to the next amplifier. [. . . ]