User manual SYLVANIA ZC320SL8

[. . . ] The lightning flash with arrowhead symbol, within an equilateral triangle, is intended to alert the user to the presence of uninsulated "dangerous voltage" within the product's enclosure that may be of sufficient magnitude to constitute a risk of electric shock to persons. Only a qualified service person should remove the cover or attempt to service this device, due to possible eye injury. FCC WARNING- This equipment may generate or use radio frequency energy. Changes or modifications to this Equipment may cause harmful interference unless the modifications are expressly approved in the manual. [. . . ] ) · The external tuner should be equipped with some kind of timer function. Using timer function of the tuner, set it to output audio/video signals when it comes to the time you want to start recording, and stop output audio/ video signals when it comes to the time you want to finish recording. Make sure to set the satellite link standby mode when you finish setting. Use [K / L] to select "Timer Programming", then press [ENTER]. Use [K / L] to select the time and recording speed, then press [ENTER]. In a second, the unit will be turned off automatically as it goes into the satellite link standby mode. To cancel the satellite link function while in the satellite link standby mode: Press [POWER] to turn on the unit. To cancel the satellite link function while the satellite link recording is in progress: Press [STOP C] on the front panel of the unit. If you have not set the clock, "Clock Setting" menu will appear at step 3. You cannot set the end time for the satellite link timer recording on this unit. Recording picture will be distorted if the copy protection signal is being detected during satellite link timer recording. You can record the satellite link by using S-video input jacks on the rear panel. When a regular timer recording and the satellite link timer recording are overlapped, those recordings are recorded as illustrated below. Connect the external device properly to either L2 (front) or L1 (rear) input jacks of this unit by using S-video or RCA audio / video cables. Front of this unit After making the connection as described above, make sure to select the appropriate video input type by following the steps in "SETTINGS FOR THE VIDEO INPUT" on page 16. Supplied cables used in this connection are as follows: · rCA audio cable (L/R) x 1 · RCA video cable x 1 Please purchase the rest of the necessary cables at your local store. When connecting an external device of monaural output to this unit, use AUDIO L jack of L2 (Front). Before recording from an external device, refer to the instructions for the connection on page 39. Turn on the TV and press [POWER], and be sure to select the input of the TV to which the unit is connected. To use the input jacks on the rear of this unit; Select "L1" by using [INPUT SELECT] or [INPUT]. To use the input jacks on the front of this unit; Select "L2" by using [INPUT SELECT] or [INPUT]. The contents of DVD are generally divided into titles, and the titles are subdivided into chapters. [. . . ] A type of display that does not split each frame into fields, and instead scans directly through all the scanlines of each frame in order. Progressive scan provides less flickering and higher image resolution than traditional (525i/480i) TV signals. Just as a book is split up into several chapters, a title on a DVD is usually divided into chapters. Each signal of luminance (Y) and component (PB/CB, PR/ CR) is independent to output so that you can experience picture color as it is. [. . . ]