User manual SYLVANIA 6325CCA

[. . . ] The user could lose the authority to operate this equipment if an unauthorized change or modification is made. RADIO-TV INTERFERENCE This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. [. . . ] ⷠFor selecting the minor channels with [K / L], please make sure the minor channel your are selecting is existed. If the timer program did not complete correctly, the error number appears in the timer programming list. Each error number means: E1-22 Recording error other E35 E37-39 than below PCA full *1 Already finalized video format disc Some portion has not been recorded because of program overlapping. Power failed No disc when recording 4-A) To delete the timer program: 1 Use [K / L] to select the program you want to delete, then press [ENTER]. 4-B) To correct the timer program: 1 Use [K / L] to select the program you want to correct, then press [ENTER]. 2 Use [K / L] to select "Program Change" , then press [ENTER]. 3 Correct the timer program by using [K / L / { / B], then press [ENTER]. A program with the error number is grayed in the timer programming list. ⷠOnce the timer programming list with error line(s) is displayed, or after canceling and setting again the timer standby mode, the program line(s) with error will be cleared. When the timer recording is proceeding, that program will be highlighted with red. If there is a power failure or this unit has been unplugged for more than 30 seconds, the clock setting and all timer programming will be lost. When connecting an external device of monaural output to this unit, use AUDIO L jack of L2 (Front). Front of this unit Supplied cables used in this connection are as follows: · rCA audio cable (L/R) x 1 · RCA video cable x 1 Please purchase the rest of the necessary cables at your local store. Use [K / L] to select desired external input position, then press [ENTER]. Use [K / L] to select the input jack type to connect, then press [ENTER]. Use [K / L] to select "General Setting", then press [ENTER]. Before recording from an external device, refer to the instructions for the connection on page 50. Turn on the TV and press [POWER], and be sure to select the input of the TV to which the unit is connected. Insert the cassette tape with an erase-protection tab into the cassette compartment. To use the input jacks on the rear of this unit; Select "L1" by using [INPUT SELECT] or [CH K / L]. ⷠTo use the input jacks on the front of this unit; Select "L2" by using [INPUT SELECT] or [CH K / L]. ⷠYou can also select "L1" or "L2" by using [the Number buttons]. [. . . ] 2V rms (input impedance: more than 22k) 1Vp-p (75) Y: 1Vp-p (75) 75 unbalanced 2V rms (input impedance: more than 22k) 2V rms (output impedance: more than 1k) C: 286mVp-p (75) Will repair this product, free of charge in the USA in the event of defect in materials or workmanship as follows: Will provide parts to replace defective parts without charge for one (1) year from the date of original retail purchase. Will provide the labor without charge for a period of ninety (90) days from the date of original retail purchase. This warranty shall not be extended to any other person or transferee. This warranty is void and of no effect if any serial numbers on the product are altered, replaced, defaced, missing or if service was attempted by an unauthorized service center. [. . . ]