User manual SWISSVOICE EPURE V2

[. . . ] In this case the transmission quality may be reduced through the increased incidence of short breaks in transmission. Normal call quality can be restored if you move slightly out of the silent zone. If the range is exceeded, the call will be disconnected unless you move back into range within ten seconds. ePure 3 ePure_GB_140311_DTP direkt 14. 03. 11 16:29 Seite 4 ePure Battery advice Use only the original battery (Li-Ion 3. 7 V / 550 mAh) as well as the original power supply (7. 5 VDC, 300mA). The handset operating times (standby 150 hours/active 10 hours) and charging times apply only if the battery is charged to the defined minimum capacity. [. . . ] Insert a space. Add new entries in the phonebook • • • • Press , select Phonebook and press OK. Enter the desired name and press the navigation key π/† for further input options. Press OK to save the entry. Edit phonebook • • • • Press , select Phonebook and press OK. Select the desired entry using the navigation key π/† or enter the first letter of the name. Press the Talk key to call the number. In the phonebook menu you have the following options: - New entry - View entry - Delete all - Direct mem - Call a programmed direct memory number. - PB Transfer – Copy phonebook to another handset. 8 ePure ePure_GB_140311_DTP direkt 14. 03. 11 16:29 Seite 9 ePure Direct memory Phone numbers from the phone book can be assigned to numerical keys 1 to 9. Programming direct memory keys • • • • • Press , select Phonebook and press OK. Select the desired entry from the phonebook using the navigation key π/† and press OK. Calling a direct memory number To call a direct memory number, press the corresponding key for approx. The programed number is called. Calls list The control LED on the side of the handset flashes when you have one or more missed calls. To use this function, the caller's number must be transmitted (CLIP). Contact your network operator for further information. Call a number from the calls lists • • • • Open the calls list by pressing the navigation key π. If the caller's number is suppressed, only Withhold is displayed. The call is not entered in the call list. ePure 9 ePure_GB_140311_DTP direkt 14. 03. 11 16:29 Seite 10 ePure Edit calls list • Open the calls list. You have the following options: - Edit entry - Save Number – Store number in the phonebook. - Delete All – Delete all entries. Extending the ePure The delivered handset is already registered on to base station. If you register your ePure handset with a "third party" base station or a "third party" handset on your ePure base station (GAP), you may not be able to use some functions or only to a limited extent. Register new handsets Registering an additional handset with the main base station (the base station you have connected to the telephone network): 1. Before registering an additional handset, you first need to unregister it from its original base station: • Press , select Advanced set and press OK. Preparing the main base station (base you have connected to the telephone network) for registering additional handsets: • On the base station you want to use as the main base station, press and hold down the Paging key for around 10 seconds (the Paging key is on the underside of the base station). • • • 10 Registering an additional handset: Press , select Advanced set and press OK. ePure ePure_GB_140311_DTP direkt 14. 03. 11 16:29 Seite 11 ePure • • • • Base 1 2 3 4 is displayed on the handset. If registration is successful you will hear the dialling tone when you press the Talk key , and after one minute the handset will go to standby mode. - Language - Room monitor - You need two handset to use this function. You can then establish a connection to this handset from a second handset and monitor the room acoustically. [. . . ] All defects attributable to material and manufacturing faults will be corrected free of charge within the warranty period, either by repairing or replacing the defective equipment. 14 ePure ePure_GB_140311_DTP direkt 14. 03. 11 16:29 Seite 15 ePure The warranty does not cover expendable materials (battery cells), defects which affect the value or use of the equipment only insignificantly, and damage caused by incorrect use, ordinary wear and tear, or manipulation by third parties. This warranty does not cover consequential damage caused by the use, failure or defectiveness of the product. In particular, no liability whatsoever is accepted for damage to property and pecuniary loss. [. . . ]