User manual SWEEX RO003 QUICK_START_GUIDE

[. . . ] This installation procedure will show you step by step how to setup the router. If your provider can not be configured with the Setup Wizard, contact your provider for the correct settings and enter them manually. Introduction · · · · Do not expose the Sweex Broadband Router to extreme temperatures. Do not place the product in direct sunlight or in the direct vicinity of heating elements. Do not use the Sweex Broadband Router in extremely dusty or moist surroundings. [. . . ] Left in the column, click on "Internet Provider Setup" or, if you see the screen below, click on "Next". 3. In order to check whether the Internet connection has been set up successfully, go to the status screen by clicking "Status" left in the column. You have now completed the configuration and are ready to surf the Internet. 9 English version 6. If your IP address continues to be displayed as 0. 0. 0. 0, click on "Renew". If after 1 minute your IP address still continues to show as 0. 0. 0. 0, check the above steps. Disconnect the network cable between the router and the modem at the "WAN" port. Switch on the modem and wait until it is fully started up and all the correct lights are lit. Reconnect the network cable between the modem and the router via the "WAN" port of the router. Connect the router via 192. 168. 23. 1 and check your Internet connection in the status screen. Setting 2 DHCP with hostname Important: when configuring the router, always use the computer with which you were connected to the Internet prior to connecting the router. Log in to the Router (see the section "Accessing the Router" above). Left in the column, click on "Internet Provider Setup" or click on "Next". 10 English version c. Under "Hostname" enter the hostname you received from your provider. In order to enter the MAC address of your computer into the router, click "Clone MAC". In order to check whether the Internet connection has been set up successfully, go to the status screen by clicking "Status" left in the column. You have now completed the configuration and are ready to surf the Internet. i. If your IP address continues to be displayed as 0. 0. 0. 0, click on "Renew". If after 1 minute your IP address still continues to show as 0. 0. 0. 0, check the above steps. Disconnect the network cable between the router and the modem at the "WAN" port. Switch on the modem and wait until it is fully started up and all the correct lights are lit. Reconnect the network cable between the modem and the router via the "WAN" port of the router. Connect the router via 192. 168. 23. 1 and check your Internet connection in the status screen. 11 English version Setting 3 PPPoE 1. Log in to the Router (see the section "Accessing the Router" above). [. . . ] Click "Save" to save the settings. How to assign a fixed IP address to a computer This is only required for computers for which you want to open ports by means of the Forwarding or DMZ feature. Complete the steps in chapter "Configuring the computer to connect to the router". Instead of selecting "Obtain an IP address automatically" (Obtain an IP address automatically) you select "Use the following IP address" (Use the following IP address). For "Subnetmask" (Subnetmask) you enter: 255. 255. 255. 0 Both under "Default gateway" (Default gateway )and under "Preferred DNS-server" (Preferred DNS-server) you enter the IP address with which you log into the router. [. . . ]