User manual SWEEX LW310

[. . . ] English version LW310 Sweex Wireless Broadband Router 300 Mbps Important!This installation procedure will show you step by step how to setup the router. · Do not expose the Sweex Wireless Broadband Router 300 Mbps to extreme temperatures. Do not place the device in direct sun light or close to heating elements. [. . . ] This means that no matter how many computers you connect to the router, the following settings only have to be done on one computer. That is because the settings are not stored on the computer but on the router. 11 English version Important!This installation procedure will show you step by step how to setup the router. If your provider can not be configured with the Setup Wizard, contact your provider for the correct settings and enter them manually. Settings 1 DHCP without hostname (Suitable for most providers) 1. To check if the internet connection is established successfully, go to the status screen by clicking on "System Status" in the left column. Your internet "WAN IP" will appear in the "Network Status" part. You are now done configuring and can now use internet. 1 English version 6. When your "WAN IP" stays 0. 0. 0. 0, click on the "Renew" button. When your IP-address is still 0. 0. 0. 0 after 1 minute, check the above steps. Disconnect the cable between the router and modem from the "WAN" port. Turn on the modem and wait until it is fully started and the right lights are lit. Reconnect the network cable between the modem and router by putting it in the "WAN" port of the router. Connect to the router via 192. 168. 31. 1 and check your internet connection in the status screen. Settings 2 DHCP with hostname Important: When configuring the router, always use the computer that had the internet connection before you connected the router. These setting belong to providers that use a DHCP-connection. 1 English version 4. 7. At "Hostname" enter the hostname the provider gave you. Disconnect the cable between the router and modem from the "WAN" port. Turn on the modem and wait until it is fully started and the right lights are lit. Reconnect the network cable between the modem and router by putting it in the "WAN" port of the router. Connect to the router via 192. 168. 31. 1 and check your internet connection in the status screen. Settings 4 PPTP 1. This setting belongs to providers that use a PPTP connection. 1 English version 4. 7. At "Username" enter the user name that your provider gave you. At "Password" enter the required password and click "Next". [. . . ] External~Internal Port; When you only want to open port 500, so only one port, enter the same port number in both boxes. Click on "Port Range Forwarding" on the left and enter 500 in the left box and 600 in the right box. ) 2. To IP Address; Enter the IP-address of the computer, server or game console you want to open the ports for. The entered entry appears. DMZ In some situations, or when using a game console, you can choose to let the computer or game console pass the firewall entirely. [. . . ]