User manual SWEEX LW050V2

[. . . ] Englishversion LW050v2/LW050v2UK Sweex Wireless Broadband Router 54 Mbps Introduction First of all, many thanks for purchasing this Sweex Wireless Broadband Router 54 Mbps. The Sweex Wireless Broadband Router 54 Mbps enables you to share a broadband Internet connection and to set up your own wireless network. To ensure this product operates correctly, we advise you to carefully read this manual first. If despite this manual you still experience problems during installation or operation of this product, go to www. sweex. com and look under the heading service & support. [. . . ] Regardless of the number of computers you connect to the router, the following settings only need to be done on one computer. That is because the settings are not stored on the computer, but on the router. 13 Englishversion Setting1DHCPwithouthostname 1. Disconnect the network cable between the router and the modem at the "WAN" port. Switch on the modem and wait until it is fully started up and until all the correct lights are lit. Reconnect the network cable between the modem and the router via the "WAN" port of the router. Connect the router via 192. 168. 50. 1 and check your Internet connection in the status screen. Setting3PPPoE 1. Under "User Name" enter the user name you received from your provider. In order to check whether the Internet connection has been set up successfully, go to the status screen by clicking "Status" left in the column. You have now completed the configuration and are ready to surf the Internet. If after 1 minute your IP address continues to show as 0. 0. 0. 0, check your settings again and complete the following steps: 1. Disconnect the network cable between the router and the modem at the "WAN" port. Switch on the modem and wait until it is fully started up and until all the correct lights are lit. Reconnect the network cable between the modem and the router via the "WAN" port of the router. Connect the router via 192. 168. 50. 1 and check your Internet connection in the status screen. 1 Englishversion Setting4PPTP 1. This setting is for providers who use a PPTP or KPN Mxstream connection. Under "User Name" enter the user name you received from your provider. Next to this button, the message "Connected" will appear and your Internet IP address will be displayed under "Internet IP Address". You have now completed the configuration and are ready to surf the Internet. If after 1 minute the router continues to show as "Disconnected", check your settings again and complete the following steps: 1. Disconnect the network cable between the router and the modem at the "WAN" port. Switch on the modem and wait until it is fully started up and until all the correct lights are lit. Reconnect the network cable between the modem and the router via the "WAN" port of the router. [. . . ] Click "Save" to save the settings. HowtoassignafixedIPaddresstoacomputer This is only required for computers for which you want to open ports by means of the function Forwarding or DMZ. Complete the steps in chapter "Configuring the computer to connect to the router". Instead of selecting "Obtain an IP address automatically" (Obtain an IP address automatically) you select "Use the following IP address" (Use the following IP address). For "Subnetmask" (Subnetmask) you enter: 255. 255. 255. 0 Both under "Default gateway" (Default gateway) and under "Preferred DNS-server" (Preferred DNS-server) you enter the IP address with which you log into the router. [. . . ]