User manual SUPERMICRO X9DRI-F

[. . . ] Instead it shall be handed over to the applicable collection point for the recycling of electrical and electronic equipment. By ensuring this product is disposed of correctly, you will help prevent potential negative consequences for the environment and human health, which could otherwise be caused by inappropriate waste handling of this product. For more detailed information about recycling of this product, please contact your local Civic Office, your household waste disposal service or the shop where you purchased the product. Disposal of waste batteries (applicable in the European Union and other European countries with separate collection systems) This symbol on the battery or on the packaging indicates that the battery provided with this product shall not be treated as household waste. [. . . ] If registration is not performed along with the installation procedure, follow the steps below. If you connect a registered USB device containing analyzed tracks, the USB device can be unregistered again. To enable the SensMeTM function on this unit, tracks need to be analyzed and transferred to the registered USB device, using "Content Transfer. to change the channel: Press / (ALBUM /) to select the desired channel. To change the track: Press +/­ repeatedly until the desired track appears, then press the control dial. Note If the connected USB device contains many tracks, it may take time for "SensMeTM channels" to start, due to data reading. "SensMeTM channels" automatically group tracks into channels by their tunes. In these Operating Instructions, "iPod" is used as a general reference for the iPod functions on the iPod and iPhone, unless otherwise specified by the text or illustrations. For details on the compatibility of your iPod, see "About iPod" (page 29) or visit the support site on the back cover. Slide the USB cover, then connect the iPod to the USB connector with the USB connection cable for iPod (not supplied)*. The tracks on the iPod start playing automatically from the point last played. The following items can be set: EQ7 PRESET (page 23) EQ7 SETTING (page 23) POSITION POSITION (Listening Position setting) (page 24) ADJUST POS*1 (Listening Position adjustment) (page 24) SW POSITION*1 (Subwoofer Position) (page 24) BALANCE Adjusts the sound balance: "RIGHT-15" ­ "CENTER" ­ "LEFT-15. Rotate the control dial until "START WHITE" appears, then press it. ) AUX VOLUME*2 (AUX Volume level) Adjusts the volume level for each connected auxiliary equipment: "+18 dB" ­ "0 dB" ­ "­8 dB. " This setting negates the need to adjust the volume level between sources. "CUSTOM" of EQ7 allows you to make your own equalizer settings. Rotate the control dial until "EQ7 SETTING" appears, then press it. Rotate the control dial until "BASE" appears, then press it. Advanced Sound Engine creates an ideal incar sound field with digital signal processing. You can select an equalizer curve from 7 equalizer curves (XPLOD, VOCAL, EDGE, CRUISE, SPACE, GRAVITY, CUSTOM or OFF). Rotate the control dial until "EQ7 PRESET" appears, then press it. Rotate the control dial until the desired equalizer curve appears, then press it. [. . . ] The leads are not matched correctly with the car's accessory power connector. ­ Connect a power antenna (aerial) control lead (blue) or accessory power supply lead (red) to the power supply lead of a car's antenna (aerial) booster (only when your car has built-in radio antenna (aerial) in the rear/side glass). ­ If the auto antenna (aerial) will not go up, check the connection of the power antenna (aerial) control lead. The station does not broadcast any traffic announcements despite being TP. [. . . ]