User manual SUB-ZERO WS-30

[. . . ] WINE STORAGE USE & CARE GUIDE Caring for your Sub-Zero and everything in it. Contents Sub-Zero Wine Storage . 23 Features and specifications in this guide and on the website are subject to change at any time without notice. Check our website, subzero. com, for the most up-to-date specifications. Important Note To ensure the safe and efficient use of Sub-Zero equipment, please take note of the following types of highlighted information throughout this guide: IMPORTANT NOTE highlights information that is especially important. CAUTION signals a situation where minor injury or product damage may occur if instructions are not followed. [. . . ] Watch that fingers are not placed in the door opening on the hinge side when the door is open. 90° DOOR STOP If your wine storage unit is positioned in a corner, you may want to limit the door opening to 90°. IMPORTANT NOTE: A 90° door stop is not available for models 424 and 424FS. For models 427 and 427R, a 90° door stop built into the hinge system. You can easily actuate the stop by using a blade-type screwdriver and rotating the brass cam in both the top and bottom hinges. You must position both stops at 90° if you want to safely use the door. You can go to the maximum of a 105° door opening by using the screwdriver and rotating the brass cam to the next stop. For model WS-30, a 90° door stop ships with the unit and is located behind the flip-up grille. 90° door stop (models 427 and 427R). Wine Storage Use & Care 15 subzero. com Lighting Information CABINET LIGHTING CABINET LIGHTING For models 424 and 424FS, rope-style lighting is mounted to the top of the cabinet and cascades down the entire front of the unit. Models 427, 427R and WS-30 have discreet lighting provided in two places. Rope-style lighting is mounted to the top of the cabinet and additional lighting is mounted in the control panel to illuminate the display shelf. These lights have an extended life and it should be some time before they need to be replaced. If you have problems with the cabinet lighting or need replacements, contact your Sub-Zero authorized service center or call 800-222-7820. DRAWER LIGHTING Cabinet lighting (models 427, 427R and WS-30). Drawer compartment lighting (model 427R). DRAWER LIGHTING--MODEL 427R Shut off power to the unit before replacing light bulbs. Wear protective gloves when handling bulbs. Lighting is recessed into the top area of each refrigerator drawer compartment of model 427R. To replace a light bulb in the drawer compartment, you must pull the drawer out to its maximum extension. Remove the 15-watt bulb by unscrewing it from its socket and complete the reinstallation by following the reverse steps. Wine Storage Use & Care 16 Cleaning STAINLESS STEEL EXTERIOR GLASS DOOR CLEANING Classic and platinum stainless steel finishes: To clean the exterior of the classic and platinum stainless steel finishes, use a soft, nonabrasive stainless steel cleaner like Signature polish and apply with a soft 100% lint-free cloth. Carbon stainless steel finish: The carbon stainless steel finish uses the interest of brushed steel to bring out the maximum metallic luster of its charcoal background. Different light types and source locations can result in variations in shading on different components and areas of large appliances. These variations are normal with the carbon finish and add to the unique character of colored stainless steel. To bring out the natural luster of all three finishes, lightly wipe the surface with a water-dampened microfiber cloth followed by a dry polishing chamois. Better results are obtained by keeping the cloth in continuous contact with the stainless steel. The glass door panel can be cleaned using any standard glass cleaner available on the market today. INTERIOR CLEANING To clean interior surfaces and removable parts, wash with a mild solution of soap and lukewarm water with a little baking soda. Avoid getting water on lights, control panel and the solid cherry wood facing on the shelves. Do not use abrasive cleaners or cloths on any of the interior or exterior surfaces, including the glass door panel. Before cleaning the unit, shut off power to the unit at the control panel. Under no circumstances should you use a metallic or highly abrasive cleaner or cloth, as this will remove the carbon finish or scratch the classic or platinum finishes. Wine Storage Use & Care 17 subzero. com Cleaning CONDENSER CLEANING Clean the condenser area every three to six months. The cleaning schedule will depend on the amount of dust and lint that accumulates in this area. For models 424 and 424FS, the condenser is located behind the kickplate. [. . . ] For warranty purposes, you will also need the date of installation and the name of your Sub-Zero dealer. Record this information below for future reference. BEFORE CALLING FOR SERVICE Before calling a Sub-Zero authorized service center, refer to the troubleshooting guide on pages 20­21. Check the household fuse or circuit breaker to see if it has been blown or tripped and that the electrical connection to the appliance has not been disconnected. A power outage may also have caused a disruption in service. PRODUCT REGISTRATION Register your new Sub-Zero today so that we may ensure your satisfaction. [. . . ]