User manual SUB-ZERO W422210

[. . . ] With standard elements like heat sentry and dual setting halogen lighting, Wolf elevates the need for ventilation to an enjoyable perk. This 22" (559) deep model is the low-profile version, 42" (1067) wide and available in the classic stainless steel finish. While a classic stainless steel rail is standard on the (R) model, a platinum or brass rail is available as a sales accessory. [. . . ] Blower options also vary with the volume of air that needs to be moved and the length of the duct run. Refer to the end of this section for Pro ventilation recommendations and blower options. IMPORTANT NOTE: Install this ventilation hood only with a Wolf blower. Pro wall hoods require a separate, grounded 110/120 V AC, 60 Hz power supply. Placement of the electrical supply is not critical, as long as you provide a minimum of 6" (152) of 120 V AC, 60 Hz power cable. Locate electrical within the shaded area shown in the Installation illustration. Note that the location of the electrical supply will differ between vertical and horizontal discharge blowers. In addition, be aware of local codes and ordinances when installing your service. Vertical or horizontal discharge is applicable on the low-profile wall hoods. Refer to the installation instructions shipped with each Wolf product for detailed specifications. This information can also be found on our website, wolfappliance. com. Dimensions in parentheses are in millimeters unless otherwise specified. 5 Planning Information Model W422210 (R) Pro Wall Hood D U C T I N G C O N S I D E R AT I O N S Models W302210I and W362210I come with internal blowers, all other Wolf Pro low-profile wall hoods are shipped without the blower assembly. Refer to the illustration below for ducting options. Pro low-profile wall hoods have an adjustable discharge location that can run vertically or horizontally. Horizontal discharge is applicable on low-profile wall hoods (excluding Models W302210I and W362210I) using a remote blower. Refer to the Pro ventilation charts at the end of this section for recommendations and blower options. DUCTWORK INSTALLATION THROUGH ROOF Ducting considerations for Pro low-profile wall hoods. ROOF CAP OR REMOTE BLOWER ­ TRANSITION FROM 8" (203) TO 10" (254) DUCT REQUIRED FOR REMOTE BLOWER 8" ROUND DUCT SOFIT OR CABINET OR DUCT COVER TRANSITION 17 3/4"W x 4 1/4"D TO 8" ROUND 3/8"H (INCLUDING FLANGES) 9 VERTICAL DISCHARGE 10" (254) HEIGHT OF HOOD WALL HOOD REMOTE BLOWER 22" (559) DEPTH OF HOOD DUCTWORK INSTALLATION THROUGH WALL DISCHARGE COLLAR HORIZONTAL DISCHARGE* 30" TO 36" (762­914) COUNTERTOP TO BOTTOM OF VENTILATION HOOD 36" (914) STANDARD FLOOR TO COUNTERTOP HEIGHT *HORIZONTAL DISCHARGE APPLICABLE ON LOW-PROFILE WALL HOODS (EXCLUDING W302210I AND W362210I) USING A REMOTE BLOWER. LOW-PROFILE WALL HOODS WITH AN INTERNAL BLOWER MUST USE VERTICAL DISCHARGE. Dimensions in parentheses are in millimeters unless otherwise specified. 6 Planning Information Wolf Ventilation Recommendations WOLF BLOWER ASSEMBLIES A ventilation system must include a blower assembly. With a few exceptions where internal blowers are included, Wolf ventilation hoods and downdrafts are shipped without the blower assembly. An internal, in-line or remote blower assembly must be selected to accommodate the cooking appliance, CFM requirements and homeowner preferences. [. . . ] Model numbers for dual fuel ranges, gas ranges, sealed burner rangetops and gas rangetops indicate width and number of surface burners. Additional CFM may be required for long duct runs. P R O V E N T I L AT I O N B L O W E R O P T I O N S Pro Low-Profile Wall Hoods Blower Description 600 CFM Internal* 600 CFM Internal* 600 CFM In-Line* 600 CFM Remote 900 CFM Remote Blower Number Included with (I) Models WBLOWER-60INT (807614) BLOWER-60IL (808331) BLOWER-60REM (801640) BLOWER-90REM (801641) Wall Hood Models W302210I / W362210I W362210 / W422210 W362210 / W422210 / W482210 W362210 / W422210 / W482210 W362210 / W422210 / W482210 *Vertical discharge with 8" (203) round duct. Remote blowers are adjustable discharge with 8" (203) round duct. [. . . ]