User manual SUB-ZERO PRO 48 INSTALLATION REV A 10-2010

[. . . ] You may also check the contact & support section of our website, subzero. com. Important product information, including the model and serial number of your unit are listed on the product rating plate. The rating plate is located on the left side of the top freezer drawer compartment (drawer must be open). Refer to the illustration below. Before You Start Make sure the opening dimensions, door and drawer clearances, electrical service and plumbing are correct for the model you are about to install. [. . . ] The use of core drills is not recommended to drill holes for the anchors. 23 3/4" (603) 23 3/4" (603) 23 3/4" (603) 23 3/4" (603) FINISHED FLOORING FINISHED FLOORING WALL PLATE SUBFLOORING WALL PLATE SUBFLOORING WOOD FLOOR CONCRETE FLOOR 11/2"(38) min Wood floor. Concrete floor. PRO 48 Installation 10 Unpack the Unit Uncrate the PRO 48 unit and inspect for any damages. Remove the wood base and discard the shipping bolts and brackets that hold the wood base to the bottom of the unit. Remove and discard all packing materials. IMPORTANT NOTE: Do not discard the kickplate, anti-tip bracket and hardware or corner protectors. These items will be needed for installation. Grille Removal In order to prevent damage to the PRO 48 grille, the top grille assembly should be removed prior to moving the unit. To remove the grille assembly, pull out on the bottom edge of the grille and tilt the grille frame forward. Disconnect the network cables which connect the exterior temperature displays on the grille to the display module. Cut the two white cable ties which attach the network cables to the right grille support and disconnect the cables. The cable ties should be replaced with the extra cable ties provided, once the unit is properly installed. Remove the three grille bolts from base of the grille and the upper grille screw. Reverse this procedure to reinstall the grille assembly. Retract the front leveling legs all the way up to allow the unit to be moved into position more easily. You will extend the front leveling legs down and make adjustments once the unit is in position. IMPORTANT NOTE: Water lines must not be exposed to freezing temperatures. Exposure could cause damage to the unit and home. Level the Unit Once the unit is in position, extend the front leveling legs down by turning the legs counterclockwise and adjust the height. Turn the 5/16" hex bolt clockwise to raise the unit or counterclockwise to lower it. Refer to the illustration below for location of the rear roller base adjustment. When the unit is properly leveled, door and drawer adjustments are less likely to be necessary. IMPORTANT NOTE: Be sure to reference leveling of the unit to the floor and not surrounding cabinetry. This could affect the operation of the unit, such as door closing. To reduce the possibility of the unit tipping forward, the front leveling legs must be in contact with the floor. REAR ADJUSTMENT FRONT LEVELING LEG Rear roller base adjustment. PRO 48 Installation 13 subzero. com/specs Door Adjustment Make sure both doors of the PRO 48 are properly aligned for function and appearance. If not, adjustments can be made to the cabinet hinges. IMPORTANT NOTE: The unit must be properly leveled before adjusting hinges. The doors of the PRO 48 are very heavy. Use care when removing them. If the PRO 48 is properly installed and leveled, it may still be necessary to adjust doors left to right. Adjustments are performed at the top and/or bottom cabinet hinges. HINGE ADJUSTMENT 1) Lift up the vent portion of the top grille. 2) Remove the door by opening to approximately 90° and lifting the door off cabinet hinges. With the door open, using the Allen wrench provided, turn the adjustment screw to adjust the cabinet hinge. [. . . ] When calling for service, you will need the model and serial number of your unit. Both numbers are listed on the product rating plate, located on the left side of the top freezer drawer compartment (drawer must be open). Refer to the illustration below. If you are storing or disposing of your old refrigerator or freezer, please do it safely. Child entrapment accidents can be tragic. RATING PLATE Location of rating plate (open drawer). The information and images in this guide are the copyright property of Sub-Zero, Inc. [. . . ]