User manual SUB-ZERO GASRANGETOP INSTALL GUIDE

[. . . ] The rating plate is located under the drip pan that supports the cooking grates, on the left inside wall of the rangetop. The rating plate for French Top models (except Model RT484F) is located on the right inside wall. Model Number Serial Number C O N TA C T I N F O R M AT I O N Wolf Customer Service: 800-332-9513 Website: wolfappliance. com Location of rating plate inside rangetop Rating plate location 3 W O L F G A S R A N G E TO P S B E F O R E YO U S TA RT If the information in this book is not followed exactly, a fire or explosion may result, causing property damage, personal injury or death. IMPORTANT NOTE: Proper installation is your responsibility. Installations must be performed by a qualified or licensed contractor, plumber or gas fitter, qualified or licensed by the state, province or region where this appliance is being installed. [. . . ] Always consult your HVAC professional for more concise blower requirements. IMPORTANT NOTE: When installing a ventilation hood, refer to the specific requirements of the hood for the minimum dimension to countertop. ACCESSORIES Optional accessories are available through your Wolf dealer. To obtain local dealer information, visit the Locator section of our website, wolfappliance. com. Keep combustibles such as solvents, cleaning fluids, mops and rags, away from the area surrounding all gas appliances. Fresh Air Intakes Location of fresh air intakes Dimensions in parentheses are in millimeters unless otherwise specified. 5 W O L F G A S R A N G E TO P S I N S TA L L AT I O N S P E C I F I C A T I O N S MINIMUM C L E A R A N C E S Wolf gas rangetops come in 36" (914) and 48" (1219) widths. Illustrations on pages 8­ 9 provide the overall dimensions and installation specifications for each width of gas rangetop. Refer to the Installation Specifications illustration for your model on pages 8­ 9 for the exact rough opening dimensions and location of the gas and electrical supply. IMPORTANT NOTE: Cabinet opening dimensions shown in the Installation Specifications illustrations must be used. These dimensions provide for required clearances. IMPORTANT NOTE: Caution must be used in planning the proper installation of the Wolf gas rangetop to avoid fires or damage to adjacent cabinetry or kitchen equipment. Be sure to follow the minimum clearances established in the finished rough opening dimensions. Refer to the Installation Specifications illustrations for your model on pages 8­ 9 for the exact rough opening dimensions. WA L L I N S TA L L AT I O N S Minimum clearances to combustible surfaces: Minimum 18" (457) clearance from bottom of upper cabinet to countertop, within 6" (152) minimum side clearance. Minimum spacing between overhead side cabinets must be greater than or equal to the nominal width of the rangetop. The maximum depth of overhead and side cabinets is 13" (330), within 6" (152) side clearance. 0" (0) clearance for adjacent combustible materials below the countertop, both sides and rear. Bottom of ventilation hood must be 30" (762) minimum to 36" (914) maximum from countertop. 6 I N S TA L L AT I O N I N S T R U C T I O N S MINIMUM C L E A R A N C E S W A L L I N S TA L L A T I O N S Minimum clearances for gas rangetops without a ventilation hood: Surface Burners or Griddle (G) Models: 30" (762) minimum vertical distance from countertop to combustible materials above the rangetop. Charbroiler (C) Models: 36" (914) minimum vertical distance from countertop to combustible materials above the rangetop. I S L A N D | P E N I N S U L A I N S TA L L A T I O N S Minimum clearances to combustible surfaces: Island Installations: Minimum 12" (305) clearance to rear wall that rises above the countertop. Peninsula Installations: Minimum 6" (152) clearance to side walls and minimum 12" (305) clearance to rear wall that rises above the countertop. Failure to do so can result in explosion, fire or death. IMPORTANT NOTE: The gas rangetop must be connected to a regulated gas supply. The gas supply line must be of adequate size to properly service all gas appliances. If local codes permit, a certified, 3' (. 9 m) long, 1/2" or 3/4" ID flexible metal appliance connector is recommended for connecting this rangetop to the gas supply line. IMPORTANT NOTE: The supply line must be equipped with an approved external gas shut-off valve located near the rangetop in an accessible location. [. . . ] Disconnect the gas supply and electrical connections to the unit, then remove the rangetop. Reinstall in the reverse order and be sure to check the gas connection for leaks. Refer the Wolf Gas Rangetops Use & Care Information included with the rangetop for cleaning recommendations. 14 I N S TA L L AT I O N I N S T R U C T I O N S I F Y O U N E E D S E RV I C E If service is necessary, maintain the quality built into your gas rangetop by calling a Wolf authorized service center. To obtain the name and number of a Wolf authorized service center, check the Locator section of our website, wolfappliance. com or call Wolf Customer Service at 800-332-9513. [. . . ]