User manual SUB-ZERO DOWNDRAFTUC GUIDE

[. . . ] Any violation of this application may void your warranty for one or both products. C O N TA C T I N F O R M AT I O N Wolf Customer Service: 800-332-9513 Website: wolfappliance. com 3 S A F E T Y INSTRUCTIONS AND PREC AUTIONS IMPORTANT NOTE: Read all safety instructions before using this appliance. Read this Use & Care Information carefully before using your new downdraft ventilation system to reduce the risk of fire, electric shock or injury to persons. Installation work and electrical wiring must be done by qualified person(s) in accordance with all applicable codes and standards, including fire-rated construction codes and standards. Use this downdraft only in the manner intended by Wolf Appliance Company. [. . . ] BLOWER OPTIONS Wolf downdraft Models DD30I, DD36I and DD45I include a 500 CFM internal blower. Models DD30R, DD36R and DD45R are shipped without a blower assembly and can be used with the remote blowers listed below. Models DD30R, DD36R and DD45R 900 CFM Remote Blower 1200 CFM Remote Blower 1500 CFM Remote Blower 801641 801642 804701 C O N T RO L K I T S IMPORTANT NOTE: The downdraft must be used with a Wolf-approved control module and top cover. The remote-mounted control module and top cover are available in the classic, platinum and carbon stainless steel finish for Models DD30 and DD36, and classic stainless steel only for Model DD45. The control kit, available as a sales accessory for Models DD30 and DD36 and included with Model DD45, includes the control module, top cover, mounting brackets, DIN connector and mounting hardware. Models DD30I and DD30R Classic Stainless Platinum Stainless DD30CONTROL/S DD30CONTROL/P DD30CONTROL/B IMPORTANT NOTE: Blower options vary with the cooking surface. For recommendations, refer to the Wolf Design Guide found on the Wolf website, wolfappliance. com. Carbon Stainless Models DD36I and DD36R Classic Stainless Platinum Stainless Carbon Stainless DD36CONTROL/S DD36CONTROL/P DD36CONTROL/B 7 W O L F D OW N D R A F T U S E & C A R E D O W N D R A F T CONTROLS To activate your new Wolf downdraft, press the UP/DOWN button on the control module. Once the UP/DOWN button is pressed, the downdraft blower will turn on at the last speed used, or on medium for first time use. To adjust the speed of the blower, press the HIGH, MEDIUM or LOW button. The LED next to the FILTER button on the control module will illuminate when it is time to clean the filters. This indicator light comes on after approximately 30 hours of operation. D E L AY- O F F F E A T U R E The delay-off feature will allow the downdraft blower to continue operating at the selected speed for approximately five minutes after the DELAY button has been pressed. This feature allows you to leave the cooking area, while the downdraft system is still in operation, it will then shut off and the chimney will stay up. In delay-off mode, both the DELAY LED and the corresponding blower speed LED will be illuminated. If the blower is on high speed and the DELAY button is pressed, the blower will stay on high speed for five minutes. It will then switch to low speed for an additional five minutes before turning off. If the blower is on medium speed and the DELAY button is pressed, the blower will stay on medium speed for five minutes. It will then switch to low speed for an additional five minutes before turning off. If the blower is on low speed and the DELAY button is pressed, the blower will stay on low speed for five minutes before turning off. If the DELAY button is pressed when the blower is off or when the chimney is down, no operation will take place. If the DELAY button is pressed when the unit is already in delay-off mode the delayoff feature will be cancelled. Three-speed blower controls Activation button Filter clean LED indicator Delay-off feature Downdraft control module 8 W O L F D OW N D R A F T U S E & C A R E GENERAL C A R E Most surfaces of your downdraft ventilation system are stainless steel or aluminum. Although these surfaces are resistant to most stains, they are not totally impervious to damage. Although they are sealed, excessive moisture may cause damage to the controls. [. . . ] This warranty does not cover any parts or labor to correct any defect caused by negligence, accident or improper use, maintenance, installation, service or repair. THE REMEDIES DESCRIBED ABOVE FOR EACH WARRANTY ARE THE ONLY ONES THAT WOLF APPLIANCE COMPANY, LLC WILL PROVIDE, EITHER UNDER THIS WARRANTY OR UNDER ANY WARRANTY ARISING BY OPERATION OF LAW. WOLF APPLIANCE COMPANY, LLC WILL NOT BE RESPONSIBLE FOR ANY CONSEQUENTIAL OR INCIDENTAL DAMAGES ARISING FROM THE BREACH OF THIS WARRANTY OR ANY OTHER WARRANTY, WHETHER EXPRESS, IMPLIED OR STATUTORY. Some states do not allow the exclusion or limitation of incidental or consequential damages, so the above limitation or exclusion may not apply to you. [. . . ]