User manual SUB-ZERO DD30

[. . . ] Wolf downdraft ventilation systems are recommended for use with Wolf electric and gas cooktops and integrated modules, excluding the unframed electric cooktops and electric grill, steamer and fryer modules. Wolf downdraft systems cannot be used with Wolf dual fuel ranges, gas ranges, sealed burner rangetops and gas rangetops. Dimensions in parentheses are in millimeters unless otherwise specified. 9/06 1 Planning Information Models DD30 I and DD30R Downdraft Systems F E AT U R E S Classic, platinum or carbon stainless steel finishes available on control module and top cover Remote mounted control module Internal, in-line and remote blower options Three-speed blower control Filter clean timer lets you know when the filter needs cleaning Delay-off feature automatically turns unit off, chimney remains up Stainless steel filter cover with dishwasher safe aluminum mesh filter LED indicators 9" (229) chimney elevation Downdraft control kit includes control module, top cover, mounting brackets, DIN connector and necessary hardware UL listed to US and Canadian safety standards Two and five year residential warranty ­ exclusions apply; warranty information can be found on our website, wolfappliance. com OVERALL DIMENSIONS 30" (762) 2 3/8" (60) 9 1/16" (230) 26 1/4" (667) 1 1/2" (38) DEPTH OF DOWNDRAFT CHIMNEY Dimensions may vary by ± 1/8" (3). [. . . ] Blower options vary with the volume of air that needs to be moved and the length of the duct run. Refer to the charts at the end of this section for cooktop ventilation recommendations and blower options. IMPORTANT NOTE: Install this downdraft only with a Wolf blower. Wolf downdraft ventilation systems require a separate, grounded 120 V AC, 60 Hz power supply. The service should have its own 15 amp circuit breaker and a grounded 3-prong receptacle should be located within the reach of the 2' (. 6 m) power cord. The specific location of the outlet is not critical, as long as it is within reach of the power cord that is located mid-way, top and bottom on the right side of the downdraft. If the 30" (762) downdraft is being installed in a 30" (762) wide cabinet, the outlet cannot be located on the back wall of the cabinet. It is recommended that the outlet be placed in an adjacent cabinet within reach of the power cord. IMPORTANT NOTE: A ground fault circuit interrupter (GFCI) is not recommended and may cause interruption of operation. In addition, be aware of local codes and ordinances when installing your service. This appliance must be used with a Wolf approved remote mounted control module and top cover, which is included in the downdraft control kit, available as a sales accessory. Installation of the control module must be within 10' (3 m) of the downdraft assembly and a minimum of 4" (102) from the outer edge of cooktop element or burner. You will be required to drill three holes and connect the two units by the provided wire. If a 30" (762) downdraft is installed in combination with two integrated modules, an integrated module support for downdraft ventilation (ISUPPORT) is required. Refer to the installation instructions shipped with each Wolf product for detailed specifications. Dimensions in parentheses are in millimeters unless otherwise specified. 5 Planning Information Models DD30 I and DD30R Downdraft Systems D U C T I N G C O N S I D E R AT I O N S Except for Models DD30I, DD36I and DD45I, which include a 500 CFM internal blower, Wolf downdrafts are shipped without the blower assembly. In-line and remote blower assemblies are available through your Wolf dealer. To obtain local dealer information, visit the Locator section of our website, wolfappliance. com. IMPORTANT NOTE: Install this downdraft ventilation system only with a Wolf blower. Wolf downdraft systems have an adjustable discharge that will allow you to negotiate ducting around floor joists and other obstacles. Three different discharge locations are available with side to side adjustment for accurate alignment of ductwork. [. . . ] Refer to the illustrations below for dimensions of Wolf in-line and remote blowers. (83) x 10" (254) duct for internal blower, no transition required. 3 1/4" (83) x 14" (254) duct for in-line and remote blowers. [. . . ]