User manual SUB-ZERO 700BR-PS

[. . . ] It is a perfect illustration of the concept of a refrigeration system where you can place units where they make the most sense. They can stand alone or work together with other Sub-Zero models to satisfy anyone's needs. Many homeowners are using them to supplement the main Built-In unit that is installed in the home. With a temperature range of 34°F (1°C) to 45°F (7°C), they are perfect for beverages and vegetables in the island application. Dimensions in parentheses are in millimeters unless otherwise specified. [. . . ] In addition, any decorative base molding must be removable for possible servicing and cleaning of the condenser. We recommend using D-style handles, which should be located on the top, center area of the drawer panel. Two Integrated units may be installed next to one another. A 115 volt, 6OHz, 15 amp circuit breaker and electrical supply are required. All Integrated models are equipped with a power supply cord with a 3-prong grounding plug, which must be plugged into a mating 3-prong grounding type wall receptacle. The electrical outlet must be placed so the grounding prong is to the right of the thinner blades. Locate electrical within the shaded area shown in the installation illustration on page 4. Do not under any circumstances remove the power supply cord ground prong. In addition, be aware of local codes and ordinances when installing your service. The Integrated Refrigeration Installation Instructions packed with the appliance will give you step-by-step procedures for making sure the unit is installed properly. Dimensions in parentheses are in millimeters unless otherwise specified. 5 Planning Information Integrated Model 700BR C A B I N E T RY A P P L I C AT I O N S Integrated refrigeration is compatible with virtually any style and look of cabinetry. Because of the precise application and the look you may want to achieve, there are important questions you need to answer before ordering panels for the drawers. As you look at styles of cabinets, keep some important facts in mind: IMPORTANT NOTE: The depth of each Integrated unit is 24" (610) from the front of the unit to its back. You must allow for the thickness of the panel you are applying when planning for the finished rough opening depth if you want the front panel to be flush with surrounding cabinetry. You may have to move the unit back into drywall or bring the cabinets forward to achieve a flush fit. Weight Limitations ­ The weight of each drawer panel cannot exceed 12 lbs (5 kg). Panel Thickness ­ Drawer panels must be a minimum of 5/8" (16) thick. The toe kick clearance can vary with the height of the lower drawer panel; the maximum panel height is 16 11/16" (424). You must keep a minimum space of 4" (102) clear below the bottom edge of the lower drawer panel so the unit can be properly vented. IMPORTANT NOTE: The inside edges of the rough opening, as well as the sides and a portion of the backside of the decorative panels will need to be finished, as they will be exposed when the drawers are open. [. . . ] IMPORTANT NOTE: You must keep a minimum space of 4" (102) clear below the bottom edge of the lower drawer panel so the unit can be properly vented. In addition, any decorative base molding must be removable for possible servicing and cleaning of the condenser. The illustration below shows the area below the lower drawer where the operating mechanical equipment of the Integrated unit is housed. IMPORTANT NOTE: The depth of each Integrated unit is 24" (610) from the front of the unit to its back. [. . . ]