User manual SUB-ZERO 648PRO-PS

[. . . ] Planning Information Built-In Model 648PRO Side-by-Side Refrigerator / Freezer Stainless steel construction Dual refrigeration system Easy-access grille Exterior temperature display Water filter Microprocessor and interior control panel Alarm Sabbath Mode Model 648PRO Free-Standing or Built-In Auto-close hinge system Adjustable spill-proof glass shelves Adjustable stainless steel shelves Slide-out stainless steel bins Crisper drawer Automatic ice maker Drawers with dividers This appliance is certified by Star-K to meet strict religious regulations in conjunction with specific instructions found on www. star-k. org. The Sub-Zero Model 648PRO sideby-side refrigerator / freezer is available in the stainless steel design application with classic stainless steel finish only. Model 648PRO can be built-in or, with the free-standing accessory kit, used in a free-standing application. of 100% steel (and maybe a bit of brashness), the Model 648PRO is no less than a masterpiece of preservation. Its sculpted metal, dual refrigeration and advanced controls marry performance, and design in a bold new way for home refrigeration. [. . . ] In flush built-in installations, the front of the face frame will be flush with surrounding cabinetry. The depth of Model 648PRO from the back of the unit to the front of the face frame is 25 7/8" (657). In flush built-in applications, your design may necessitate moving the unit back, or cabinets forward to achieve a flush fit. The anti-tip bracket must be installed to prevent the unit from tipping forward. Allow the doors to open a minimum of 90° or you'll have problems removing shelves. With the door opening at 90°, you may have to move shelves slightly to clear the door interior. Refer to the minimum door swing clearance in the specifications chart. For corner installations, allow for a minimum 3" (76) filler so that the door can open to 90°. Model 648PRO comes with an automatic ice maker and an integrated water filtration system. This system operates on water pressure between 35 psi (2. 4 bar) and 120 psi (8. 3 bar). To rough in the water supply, connect a 1/4" OD copper line to the house supply, being sure to use an easily accessible shut-off valve between the supply and the unit. To obtain local dealer information, visit the Locator section of our website, subzero. com. IMPORTANT NOTE: A reverse osmosis system can be used with Model 648PRO, provided there is constant water pressure of 20 psi (1. 4 bar) to 120 psi (8. 3 bar) supplied to the unit at all times. In this application, the integrated water filtration system must be set to bypass mode. The water line should be routed up through the floor within 1/2" (13) from the back wall and no higher than 3" (76) off the floor. [. . . ] Locate electrical within the shaded area shown in the Installation illustration. In addition, be aware of local codes and ordinances when installing your service. Refer to the PRO 48 Installation Instructions packed with the appliance, which provides step-by-step procedures for making sure the unit is installed properly. Dimensions in parentheses are in millimeters unless otherwise specified. 5 [. . . ]