User manual SUB-ZERO 315W-PS

[. . . ] Model 315W, a single-zone undercounter Wine Storage unit, comes only with a full-view glass door and can be ordered as an overlay or classic stainless steel unit. Dimensions in parentheses are in millimeters unless otherwise specified. 10/06 1 Planning Information Wine Storage Model 315W F E AT U R E S Single-zone undercounter Wine Storage unit with 26 (750 ml) bottle capacity Overlay and classic stainless steel design options Sturdy, rustproof wire shelves accommodate standard 750 ml bottles, half-bottles, as well as magnums Roller-glide shelves faced with natural cherry wood have a three-quarter extension for easy access Full-view glass door standard with UVresistant glass protection Unit comes standard with high altitude glass door Discreet low voltage interior lighting UL approved for US and Canada Two, five and twelve year residential warranty--exclusions apply; warranty information can be found on our website, subzero. com OVERALL DIMENSIONS 15 1/8" (384) 2 1/8" (54) 15 1/8" (384) 19" (483) 34 1/16" (865) 30 1/16" (764) 33 5/8" (854) 14 1/4" (362) 16 5/8" (422) 180° 90° DOOR OPENING 4" (102) 19" (483) FRONT VIEW SIDE VIEW 120° TOP VIEW 1/2" (13) ± height adjustment in leveling legs. Dimensions may vary by ± 1/8" (3). Dimensions in parentheses are in millimeters unless otherwise specified. 2 Planning Information Wine Storage Model 315W S P E C I F I C AT I O N S Model 315W Overall Width Overall Height Overall Depth MODEL OPTIONS Single-Zone Wine Storage Unit 15 1/8" (384) 34 1/16" (865) 24" (610) 26 Bottles (750 ml) 34 1/16" (865) 16 5/8" (422) 115 V AC, 60 Hz, 15 amp circuit Overlay ­ 114 lbs (52 kg) Stainless Steel ­ 118 lbs (54 kg) Overlay Design Classic Stainless Steel 315 W/O 315 W/S Wine Storage Capacity Minimum Height Required Door Swing Clearance ACCESSORIES Electrical Requirements Shipping Weight Tubular handles in classic, platinum and carbon stainless steel Polished chrome handle for overlay design Filler strip for 18" (457) openings Accessories are available through your Sub-Zero dealer. [. . . ] You can choose to replace these strips with wood more complementary to your design and surrounding cabinetry. Refer to the full-scale illustration on page 10 for dimensions on the wood facing. A 115 V AC, 60 Hz, 15 amp circuit breaker and electrical supply are required. All Sub-Zero Wine Storage units are equipped with a power supply cord with a 3-prong grounding plug which must be plugged into a mating 3-prong grounding type wall receptacle. In addition, be aware of local codes and ordinances when installing your service. Refer to the Wine Storage Installation Instructions packed with the appliance, which provides step-by-step procedures for making sure the unit is installed properly. Dimensions in parentheses are in millimeters unless otherwise specified. 5 Planning Information Wine Storage Model 315W I N T E G R AT I N G C A B I N E T RY Unless you are installing a stainless steel unit, you will need to provide a door panel frame, where wine will be seen from the outside. If you order a stainless steel unit, the Model 315W will be shipped with the panel and hardware installed and you will merely install the Sub-Zero. The door frame of the unit has pre-drilled holes for our optional handle hardware. Refer to Hardware Considerations on page 8 for specifics about installing handle hardware on this overlay application. A solid panel must not be installed on a glass door unit, as this may cause moisture to form behind the panel. O V E R L AY PA N E L S The overlay panel applied to Model 315W should not be confused with the Built-In overlay panel application. The overlay panel will consist of only a frame and would be either the 5/8" (16) or 3/4" (19) panel you may be using. It is affixed directly to the door itself with screws through a series of pre-drilled holes in the perimeter of the door itself. The glass door opening of the Model 315W is designed to be exposed to room air circulation. Also, rails and stiles can be increased in size but should not exceed cabinet manufacturers standard width. They cannot exceed overall door panel dimensions specified, as they would interfere with the operation of the door. The back sides of rails and stiles that will be visible through the glass door will need to be finished. Also, the inside edges of the frames must be finished to match the front surface. Dimensions in parentheses are in millimeters unless otherwise specified. 6 Planning Information Wine Storage Model 315W O V E R L AY PA N E L S The door frame of the unit has pre-drilled holes for our optional handle hardware. Refer to Hardware Considerations on page 8 for specifics about installing handle hardware on this overlay application. When planning to install the Model 315W next to adjoining cabinetry, you must make provisions to allow the door to open to a maximum of 145° and not hit the door panel. [. . . ] The Wine Shelf Wood Facing Dimensions illustration, on page 10, can be used as a full-scale template. You must follow the layout of this format to accommodate the shelves properly. To remove the cherry strips, take the shelves out and merely remove the screws. [. . . ]