User manual SUB-ZERO 315I

[. . . ] PG 315I Mod 2. 0 8/14/06 11:18 AM Page 1 Model 315I(P) ICE MAKER MODEL 315I(P) Automatic ice maker Reversible door hinge Water reservoir Ice scoop Large ice storage capacity Model 315I Serial and model number plate Four-sided magnetic gasket Model 315IP Drain Pump Front venting with removable kickplate Adjustable ice maker control from the full-size units, Sub-Zero offers in its Built-In and Integrated lines of refrigeration, we round out our product line-up with a line of traditional undercounter refrigeration which meets all of the exacting standards you have grown to expect from Sub-Zero. This beautifully crafted automatic ice maker is the only unit Sub-Zero offers that has the capability of providing clear ice. [. . . ] Dimensions in parentheses are in millimeters unless otherwise specified. 15 1/4" (387)* 34 1/2" (876)* 24" (610) © SUB-ZERO PLANNING GUIDE 2006 (REV 2. 0) 3 PG 315I Mod 2. 0 8/14/06 11:18 AM Page 4 Model 315I(P) I N S TA L L AT I O N I N S TA L L AT I O N N OT E S This ice maker unit can be ordered with a pump (Model 315IP) or without a pump (Model 315I). However, gravity drain models may be converted to pump models through the installation of a drain pump kit and drain pump. Specific step-by-step instructions are included with the drain pump kit. To obtain local dealer information, visit the Locator section of our website, subzero. com. The drain and inlet water tubes must be plumbed before connecting to the ice maker. For the gravity drain, all horizontal runs of drain lines must have a 1/4" (6) per 1' (305) fall. An air gap will likely be required between the ice maker drain tube and the drain / waste receptacle. A stand pipe with a trap below it would be acceptable for the drain / waste receptacle. Refer to the installation illustrations for the Model 315I (gravity drain) and the Model 315IP (drain pump). For Model 315I (gravity drain), the drain must be located in a 2" (51) area centered in the opening for the unit, 23" (651) back from the front door. Connect a OD copper line to the house supply, being sure to use an easily accessible shut off valve between the supply and the unit. 1/4" Do not use self-piercing valves. To obtain local dealer information, visit the Locator section of our website, subzero. com. [. . . ] Refer to the installation instructions packaged with the unit to understand how the panel is installed. Refer to the following chart for door panel dimensions for the Model 315I(P). H D O O R PA N E L D I M E N S I O N S W Door Panel Dimensions Door Panel Width Door Panel Height Door Panel Thickness Maximum Panel Weight 15" (381) 30 3/8" 5/8" (772) (16) min 15 lbs (7 kg) Dimensions in parentheses are in millimeters unless otherwise specified. © SUB-ZERO PLANNING GUIDE 2006 (REV 2. 0) 5 [. . . ]