User manual SUB-ZERO 30GASCOOKTOP

[. . . ] Merely turn down the illuminated knob and the lower-tier burners delivers finetuning control and True Simmer. This patented feature allows you to have the slightest of flame and enjoy a simmer with no boiling or scorching. Available in your choice of classic or platinum stainless steel finish. The sealed burners and deep recess of the seamless drawn pan area make clean up of any of those previously unsightly spills a snap. [. . . ] Locate electrical within the shaded area shown in the Installation Specifications illustration on page 4. IMPORTANT NOTE: A ground fault circuit interrupter (GFCI) is not recommended and may cause interruption of operation. When a gas cooktop is installed above cabinets, the gas and electrical placement is not critical. A grounded outlet needs to be placed within 4' (1. 2 m) of the right rear of the cooktop. A Wolf 30" (762) built-in single oven may be installed below this cooktop. For this installation, the electrical and gas supply for the cooktop should be installed in the adjacent cabinet. Be aware of the depth of the cooktop when planning for this installation. IMPORTANT NOTE: Wolf gas cooktops are designed and agency approved for installation with Wolf built-in ovens only. IMPORTANT NOTE: When a oven is installed below the cooktop, unless you are using cabinets deeper than 24" (610), it is recommended that the electrical supply for the oven be placed in an adjacent cabinet within reach of the conduit. A 2" (51) diameter hole to route the conduit through cabinetry will be required. Refer to page 6 for location of electrical supply and additional specifications. Wolf gas cooktops are designed to operate on natural gas at 5" (12. 5 mb) WC (water column) pressure or LP (propane) gas at 10" (25 mb) WC pressure. The minimum line pressure for natural gas is 7" (17. 5 mb) WC and 11" (27. 4 mb) WC for LP gas. The maximum gas supply pressure to the regulator should never exceed 14" (34. 9 mb) WC; . 5 psi (3. 5 kPa). The cooktops are supplied with a 1/2" NPT male gas connection at the right rear bottom corner of the cooktop. The male connector exits the unit straight down and you are supplied with a regulator with two female connectors. Wolf gas cooktops using natural gas function up to an altitude of 8, 000' (2438 m) without any adjustment. Natural gas installations from 8, 000' (2438 m) to 10, 000' (3048 m) need the high altitude conversion kit. LP gas installations will operate up to 10, 000' (3048 m) without adjustment. In addition, be aware of local codes and ordinances when installing your services. When multiple cooktop units are installed side by side, refer to the countertop cut-out dimensions on page 7. [. . . ] Some Wolf integrated modules can be installed together or with a 30" (762) or 36" (914) cooktop. When multiple units are installed side by side, the cut-out dimensions that are shown in the illustration are derived by adding 1 1/4" (32) additional space for each additional unit, to give you your total cut-out width. Refer to the illustration below for countertop cut-out dimensions for installation of multiple cooktops. IMPORTANT NOTE: Refer to the pages for each specific integrated module for installation limitations. IMPORTANT NOTE: Where multiple cooktops and/or modules are installed side by side, each unit must have its own separate recommended electrical circuit. [. . . ]