User manual STUV 16-CUBE

[. . . ] You have chosen to buy a Stûv fireplace ; Concept & Forme thank you for your choice. Your fireplace was designed to offer you the utmost pleasure, comfort and safety. If however you should find the slightest dissatisfaction with it, please contact your retailer. The Stûv 16 stoves (for intermittent operation) comply with the requirements of EN European Standards in terms of efficiency, gas emissions, safety etc. [. . . ] 7], with its chamfered side (on the right in the picture) towards the front of the stove. Slide both sides into the buttonholes; make sure it works properly : the articulated deflector should close as the door is being shut. Move the register hood to the right to bring its notch level with the cursor [b] and then remove it [pic. 3] ; rotate the switch in its housing until connectors are horizontal [pic. Do not refit the register hood until frame or cover have been refitted. The corner frame [c] which could also be called an invisible frame as it cannot be seen once it has been installed. It is made up of two symmetrical pieces which are assembled on each side of the fire. This solution includes an impeccable finish for the edges of the recess. The end of the frame [photo 3] must extend beyond the masonry (or the cladding) by at least 10 mm but by a maximum of 80 mm [diagram 4]. - Move register hood to the right to bring its notch level with the cursor [b] and then remove it [pic. With a frame with finish, adjust the depth so that it is fitted correctly [photo 1]. In the case of a thin frame, screw in the two M5 screws in the centre of top horizontal part [pic. Screw in the flap [b], photos 3 and 4 Check the screw on the right of the flap [photo 4] to ensure - that the magnet has sufficient force of attraction - and that the flap is vertical in a closed position. Then : - Adjust legs at both ends ; the appropriate spanner is supplied with the cover. Position the glass and press to eliminate air from the pads - Refit the register hood ; first the right screw then the left. - Slide in the cover from the top using special handles supplied [pic. 6] - A claw inside the cover needs to catch in front of the smoke outlet ; pull forward as far as possible and press in the centre of the hood so that it catches [pic. - Fix the 4 screws on either side of the stove starting with the bottom ones. Only the front vent is being used : Only the upper outlets are being used : You will have to shut the front vent by installing the shutter as shown in pic. Both upper outlets and front vent are being used : Refit the door on its hinges A spring inside the door shuts it automatically [pic. The front edge of the tablet fits between the front edge of the flap and the 2 side screws [pic. You have chosen to buy a Stûv fireplace; Concept & Forme thank you for your choice. [. . . ] Insert the 2 sides into the buttonholes; check to make sure that the mechanism is working - the articulated deflector closes when the door is closed. Wait until the stove cools down completely, Tilt the flap [photo 1], Remove the plate [photo 2], Open the door, Clean, Lubricate the guides [photo 3-a and 3-b]. Even if they appear to be in good condition, the seals may be loose and no longer ensure smoke-proofing; to check, wedge a piece of paper several cm in width into the door [photo 4]; it should remain jammed in the door. Glass door broken or cracked, seal worn-out, problems with the lining of the combustion chamber - contact your installation engineer. [. . . ]