User manual STOKKE IZI GO

[. . . ] € Make sure you can fit no more than one finger between the harness and your baby (1cm). WARNING 6 UK Stokke® iZi Go™ by BeSafe® WARNING WARNING • DO NOT use the seat positioned in the vehicle, with the carrying handle in a downward position. The warranty will not be honoured if non-original parts or accessories are used. € DO NOT use anything, such as a cushion, to raise the child seat off the passenger seat of the vehicle. [. . . ] Failure to attach properly could result in serious injury or death to your child. € When the seat is attached to the chassis of a stroller from Stokke, the combination should never be lifted up by the car seat. WARNING 8 UK Stokke® iZi Go™ by BeSafe® WARNING WARNING • Always remove your child from the seat while making adjustments to the stroller and/or the car seat. € Always make sure the carrying handle is in the carrying position before carrying. € If in doubt, consult either the child restraint manufacturer or the retailer. (EN 12790-2009): Using the seat as a reclined cradle • IMPORTANT!WARNING EN 12790-2009 • Do not use the seat as reclined cradle once your child can sit unaided. WARNING Stokke® iZi Go™ by BeSafe® UK 9 Introduction Do not use this product until you have thoroughly read and understood this user guide. Stokke® advises that child seats shall not be bought or sold second hand. Many seats sold through local advertising and car boot sales have been found to be dangerous. Using the Stokke® iZi Go™ by BeSafe® with a stroller from Stokke. Positioned in the back seat of the vehicle, you should push the front seat of the vehicle backwards, so that it is in contact with the child seat. Positioned in the front seat , you should push the front seat forwards, so that the child seat is in contact with the dashboard. If this is not possible, leave a space of minimum 25 cm between child seat and back rest of the front seat or dashboard. Stokke® iZi Go™ by BeSafe® UK 13 Fitting your child in the Stokke® iZi Go™ by BeSafe® • To position your child, you can fold the carrying handle behind the seat in 2 positions, by pressing both handle release buttons. € Position the shoulder straps: Check that the shoulder strap slots are levelled with your child's shoulders. Too high too low correct 14 UK Stokke® iZi Go™ by BeSafe® • The height of the shoulder straps can be adjusted by pulling the harness height adjuster out and moving the adjuster up or down. Pull the shoulder straps up while pressing the button of the central adjuster. When the child is positioned, place the shoulder straps over the child›s shoulders and close the buckle: click!Pull the harness strap through the central adjuster in the direction of the green arrow straight up-/forward. [. . . ] All our BeSafe child seats are tested periodically during flow production in our test laboratory. € Should this product prove faulty within 24 months of purchase due to materials or manufacturing fault, except covers and harness straps, please return it to the original place of purchase. € The guarantee is valid only if you use your seat properly and with care. Please contact your dealer and he will decide whether the seat will be returned to the manufacturer for repair. [. . . ]