User manual SPAL AS-80

[. . . ] ARMING WITH SIREN DISENGAGEMENT REMOTE CONTROL UNIT BATTERY LOW The LED on the remote control flashes when a button is pressed. When engaged, the alarm causes the direction indicators to flash 6 times quickly instead of 3. To arm the alarm without engaging the siren (optical alarm cycles only) press the P2 button of the remote control and, within 15 seconds, the P3 button. Disengagement of the siren is confirmed by 3 additional audible chirps SIREN DISENGAGED 6x 2. [. . . ] CAR LOCATOR With the alarm engaged, by pressing button P2, the direction indicators and the dome light come on for 25 seconds. STORED REMOTE CONTROLS CHECK Every time the dashboard is switched off, the LED emits a number of flashes equivalent to the number of remote controls stored in the unit. This permits checking that the number of enabled remote controls corresponds to those in possession of the user. 5. DISARMING · Press button P1 of the remote control This is confirmed by 1 flash of the direction indicators and 1 audible chirp (if on) The doors are unlocked, the LED goes off and the dome light comes on (if programmed and connected). VALET MODE When valet mode is engaged, all the alarm functions are disengaged. The VALET mode is indicated by continuous LED flashing, with dashboard on. ENTERING VALET MODE · Switch on the dashboard · Press buttons P1 and P2 at the same time for at least 2 seconds. The alarm unit gives 1 flash of the direction indicators and 1 audible chirp With the dashboard off, the LED flashes continuously 1x 1x 25 sec ALARM MEMORY If, during the previous arming time, a cause of alarm has been found, when the alarm unit is disarmed, two audible chirps will be heard and the LED will flash in a codified sequence, indicating the cause of the alarm. ALARM MEMORY 2x VALET MODE 2 sec 1x 1x EXITING FROM VALET MODE · Switch on the dashboard · Press buttons P1 and P2 at the same time for at least 2 seconds. The alarm unit gives 1 flash of the direction indicators and 1 audible chirp VALET MODE 2 sec 1x 1x 5 ENGAGEMENT · With the dashboard switched on and doors LOCKED, press the P2 button from the remote control. AUTOMATIC DOOR LOCKING AT SWITCH-ON If engaged, the alarm automatically locks the doors 10 seconds after the dashboard has switched on. When the dashboard switches off, the doors are automatically unlocked. DISENGAGEMENT With the dashboard switched on and doors LOCKED, press the P1 button from the remote control. ANTI-CARJACK OFF ANTI-CARJACK - OPERATION ACTIVE MODE - CARJACK DURING VEHICLE DRIVING · The LED comes on steady - anti-carjack on · Opening and closing of a door (the drivers is forced by the carjacker to leave the vehicle) The LED goes off and, after 20 seconds, starts to flash The alarm fails to respond to the remote control After 2 minutes, the control unit performs an alarm cycle, without arming the engine cut When the engine is next switched off, the engine cut engages · The only way to release the engine is to re-enable the remote control and enter the emergency disarming code PASSIVE MODE - CARJACK ON FETCHING VEHICLE · The LED comes on steady - anti-carjack on · Switch the engine off before opening a door · Exit from the car and lock it. The alarm works normally · On returning to the car, disarm the alarm by means of the remote control · Enter the emergency disarming code If the disarming code is not entered, the LED remains on steady The alarm fails to respond to the remote control After 2 minutes, the control unit performs an alarm cycle, without arming the engine cut When the engine is next switched off, the engine cut engages · The only way to release the engine is to re-enable the remote control and enter the emergency disarming code 10 sec 14. ALARM PASSIVE AUTOARMING If engaged, the alarm engages automatically 30 seconds after the vehicle has been left (last door closed). The passive autoarming of the alarm does not lock the doors and does not engage the electronic modules connected to the alarm unit, and is indicated in the same way as arming from remote control. ALARM ON 30 sec DISARMING With the alarm unit armed in passive mode, when a door is opened, an intermittent audible chirp is heard lasting 10 seconds, during which time the alarm unit can be disarmed before this generates an alarm cycle. 10 sec 15. ENGINE CUT PASSIVE AUTOARMING If engaged, the alarm automatically cuts the engine 90 seconds after the dashboard switches off. Passive arming of the engine cut is indicated by the LEDs coming on with short switchoffs. 6 19. AUX OUTPUT ENGAGEMENT 8 When the button P2 on the remote control is pressed twice, the AUX output of the alarm is engaged. [. . . ] After entering the fourth exact figure, the control unit goes off, unlocking the doors 90 sec 3x 3x 18. ANTI-CARJACK If engaged, in case of the car being broken into, the alarm unit gives alarm signals and engages the engine cut. The anti-carjack function can work in two distinct ways, active or passive, depending on the carjack mode. The anti-carjack function is only operative after it has been engaged. and giving 1 flash of the direction indicators and two audible chirps. [. . . ]