User manual SOUNDTECH POWER SOURCE 800

[. . . ] 13) Learn to get to know the parts which make up your dishwasher, you will use it better for it. This is where you will find the description of the controls and the internal parts. 14) This page includes useful tips to help you load your dishwasher correctly and make the most of all the available space. 15) After loading the dishes, you need to select the right wash cycle and measure out the correct dose of detergent and rinse aid. [. . . ] If you prefer to use the detergent in tablet form, then place one inside the container “D” and close the lid. Detergent and rinse aid Useful tips • Use the right amount of detergent: if you use too much, you will not get cleaner dishes, but just more environmental pollution. Check whether there is any detergent residue on the edges of the dispenser. • Keep your dishwasher detergent and rinse aid in a cool, dry place and away from children. The rinse aid container is situated on the inside of the door: It should be filled up when the low rinse aid indicator light "T" flashes. You can adapt the amount of rinse aid used by the dishwasher: regulate the adjuster F which you will find under lid C. If drops of water remain on the dishes or spotting occurs, turn the dosage adjuster to a higher setting. If, on the other hand, the dishes have white streaks, then turn the dosage adjuster down to a lower setting. Warning Three-in-one dishwasher tablets are now available on the market, and combine detergent, salt and rinse aid all in one. If the water in your area is hard or very hard, we still recommend you pour extra salt into the relevant dispenser to prevent the formation of white streaks on your dishes or on the interior of the appliance. Using a three-in-one product means it is no longer necessary to put rinse aid into the relevant container. Hot water supply following the same procedures as those indicated Adjusting the back Feet for the cold water connection. Insert the appliance into the cutout A and then adjust the height using the Anti-flooding protection screws located on the front bottom Your dishwasher is provided with a part of the machine. Use a special system which blocks the screwdriver to turn the screws in water supply in the event of leaks the clockwise or anti-clockwise inside the appliance. It is further direction to increase or decrease equipped with a water inlet hose the height respectively. That can withstand extremely high pressures and that turns bright red Cold water connection. Safety in This electric household appliance the event of flooding is ensured by should be connected to the water the second clear hose that contains Condensation-proof tape. Mains using the cold water supply the former and thus highlights the On some models, a transparent hose provided with the appliance latter when it has turned bright red. The event of replacements, use regular basis: if you see it has turned It should be stuck onto the lower original spare parts only. Bright red, then you know you have side of your wooden worktop to Connect the cold water supply to replace it as soon as possible. Protect it from the formation of hose to a 3/4 gas threaded Call for an authorised technical condensation. When not provided, this tape can connection, taking care to screw it engineer to come and replace it. [. . . ] The food particles are removed from the wash water, allowing it to be recirculated during the cycle, filtered perfectly. For this reason, it is a good idea to remove the larger food particles trapped inside the cup “C” and the semi-circular filter A after each wash; pull the cup handle upwards to remove them. The entire filter assembly should be cleaned thoroughly once a month: cup C + semi-circular filter A + cylindrical filter B. Reassemble the filter parts (as shown in the figure) and reinsert the whole assembly into the dishwasher. [. . . ]