User manual SONY CDP-C910

[. . . ] Do not connect either wire to the earth terminal in the plug which is marked by the letter E or by the safety earth symbol Y or coloured green or green-and-yellow. Before operating the player, check that the operating voltage of the player is identical with your local power supply. The player is not disconnected from the AC power source (mains) as long as it is connected to the wall outlet, even if the player itself has been turned off. If you are not going to use the player for a long time, be sure to disconnect the player from the wall outlet. [. . . ] The red circle around a disc number indicates the disc is ready to be played. When all the tracks on a disc have been played, the semicircle around the disc number disappears. When a disc compartment is recognized as empty, the semicircled disc number disappears. You can open the disc tray while playing a disc so that you can check what discs are to be played next and replace discs without interrupting playback of the current disc. While playing a disc, the display shows the current disc number, track number, playing time of the track and the music calendar. The player plays the disc on the left side compartment after the current disc, and then the one on the right side compartment. The track numbers in the music calendar disappear after they are played. When you press DISC CHECK, the play mode automatically changes to ALL DISCS Continuous Play mode. When you've opened the disc tray by pressing EX-CHANGE, you cannot use the DISC CHECK function. Even if you press DISC CHECK while "REPEAT" appears in the display (see page 10), the player stops after scanning all the discs once. If the disc is played in 1 DISC Repeat Play mode (see page 10), the current disc starts playing again. You can start Shuffle Play while playing When you want to programme the whole disc as one step, skip Step 3 and go to Step 4. Press the number buttons of the tracks you want to programme in the order you want. To programme the track numbered over 10, use the >10 button (see page 10). After one second If you've made a mistake Press CLEAR, then press the correct number button. Other discs Other tracks on the same disc Other tracks on other discs You can check your programme before or after you start playing. Each time you press this button, the display shows the track (the disc and track numbers) or the disc (the disc number and "AL" indication) of each step in the programmed order. After the last step in the programme, the display shows "End" and returns to the original display. If you check the order after you start playing, the display shows only the remaining steps. You can create your programme while checking the disc labels While the disc tray is open, follow Steps 1 to 5 with pressing DISC SKIP to check the disc labels. If you close the disc tray before Step 5, the total playing time appears in the display after a while. Each time you press these buttons, the display changes as shown below, with the tape length of one side following each indication. [. . . ] You can store this information: Group the tracks on each disc into up to 4 groups Delete unwanted tracks and store only the tracks you want While holding down ERASE and 1 on the player, press POWER to turn off and on the player. The Custom File indication lights up when you store the corresponding information. You can group the track on each disc into up to 4 groups called "clips. " Once you store a track into a clip, you can use the Music Clip every time you play the disc. [. . . ]